Advertisement
DISASSEMBLY
INSTRUCTIONS
® To Replace Faulty Components
= To Remove Escutcheon from Chassis
1. Remove seven (7) knobs from escutcheon.
1. Refer to above instructions 1 to 4.
2. Remove three (3) rear board mounting screws
2. Remove three (3) escutcheon mounting screws
Nos. 6 ~ 8, as shown in Fig. 3.
Nos. 9 ~ 11, as shown in Fig. 3.
3. Remove four (4) bottom board mounting screws
3. To reassebmle, reverse above procedure.
Nos. 1 ~ 5, as shown in Fig. 3.
. Lift cabinet from chassis assembly.
5. Unsolder faulty components and replace it with
new one.
6. To reassemble, reverse above procedure.
A
DIAL CORD STRINGING GUIDE
\
(2 turns)
CH14 (five)
CH9 (four)
Tuning Capacitor........
Opened
Position
Dial Cord Length........
165 cm
SG-250R/25Q
Advertisement
