Page 1
PFM W Art.-Nr. 40000 Original Instructions Rokamat PFM W (22WT1061) 2014/30/EU, 2006/42/EG, 2012/19/EU, 2011/65/EU, 2001/95/EG, EG No. 1907/2006 EN 62841-1:2015/AC:2015, EN 62841-2-4:2014/AC:2015, EN ISO 12100:2010-11 4) Kammerer GmbH, An der B 10, 75196 Remchingen Remchingen, 20.01.2022 Beate Kammerer Head of Technical Documentation...
PFM W en English Threaded mounting of accessories must spinning accessory may grab the surface and These symbols are (also) on the device. Contents match the grinder spindle thread. For acces- pull the power tool out of your control. sories mounted by flanges, the arbor hole of Symbols .................
[5-4] and press on. in the “Technical specifications” table at page 4. The PFM W is intended for use with original ROKA- Commissioning - Conduct a test run to check that the tool discs are MAT machines and accessories only.
During the warranty period do not loosen the The water injection can only be used to a limited Use only original ROKAMAT spare parts and work screws on the housing. Non-compliance will deem extent when using tool disks with a diameter...
Nozzle blocked. Unblock the blocked area. Lever valve blocked. Unblock the blocked point. Lever valve defective. Replace lever valve. If problems other than those listed occur, please contact your ROKAMAT service workshop or your local specialist. oder Ihren Fachhändler...
Need help?
Do you have a question about the PFM W and is the answer not in the manual?
Questions and answers