Safety Information; Lithium Battery Notice; Label Check - Pioneer XC-L77 Service Manual

XC-L77
1. SAFETY INFORMATION
LITHIUM BATTERY NOTICE
WARNING!
Lithium batteries. Danger of explo-
sion. Replacement must be done by
qualified personnel and only by fol-
lowing the instructions given in the
service manual.
This warning is stated on the product or
in the operating instructions. When replac-
ing the lithium batteries, follow the note
below.
Dispose of the used battery promptly.
Keep away from children. Do not disas-
semble and do not dispose of in fire.
The battery used in this device may present
a fire or chemical hazard if mistreated. Do
not recharge, disassemble, heat above
100°C or incinerate. Replace only with the
same Part Number. Use of another battery
may present a risk of fire or explosion.
Note: The lithium battery installation po-
sition is shown in the exploded views.
LABEL CHECK
VORSICHT | ADVARSEL
USYNLIG LASERTRALING VED
ABNING NAR SIKKERHED SAF-
BRYDERE ER UDE AF FUNKTION.
UNOGA UDSATTELSE FOR
STRALING.
VARO ! VARNING !
Avatteessa ja suajelukitus ohitetta- Osyniig laserstratning nar denna del
essa clet alttiing nukymattomille Ur Spenad och sp#ran dr urkopplad.
lasersiteilylie. Alz katso séiteeseen, Batrakta ej stralen. ARW1047
UNSICHTBARE LASER-STRAHLUNG
TRITT AUS, WENN DECKEL(ODER
KLAPPE)GEOFFNET IST! NICHT
DEM STRAHL AUSSETZEN!
CAUTION NVXK type
INVISIBLE LASER Lala
WHEN OPEN, AVOID
EXPOSURE T0 BEAM |,
CLASS 1
LASER PRODUCT CE
PONNER ELECTRONIC CORP.
MADE IN THE UK
FABRIQUE EN
GRANDE SRETAGNE
SERIAL.NO.
MYXK type
Additional Laser Caution SS
1. Laser tnterlock Mechanism
. When the cover is opened, close viewing of the objective
ADVARSEL!
Lithiumbatteri - Eksplosionsfare ved
fejlagtig handtering. Udskiftning ma kun
ske med batteri af samme fabrikat og
type. Levér det brugte batteri tilbage ti!
leverandgren.
Denne advarsel or angivet pa produktet
eller i brugsvejledningen. Ved udskiftning
af lithium batterierne folges nedenstaende
anveisning.
Batterierne ma kun udskiftes med batteri-
er af samme type og marke.
The loading position detect switch (in CD mechanism
assembly) is set to "CLMP ON(CD CLOSE)" (ON:low
level,OFF:high level) position, the system control
1C(1C5501) get the "CLMP" signal, and hand the laser
"LDON" signal to 101101.
Then a laser diode can be lighted except when the level of
signal CLMP is low.
The interlock also does not function in the test mode.
Laser diode oscillation will continue, if pin 1 of CXA1821M
(101101) on the RF UNIT is connected to GND, or pin 19 is
connected to !ow level (ON), or else the terminals of
Q1101 are shorted to each other (fault condition).
lens with the naked eye will cause exposure to a Class 1
laser beam.
Refer to page 42.
IMPORTANT
THIS PIONEER APPARATUS CONTAINS
LASER OF CLASS 1.
SERVICING OPERATION OF THE APPARATUS
SHOULD BE DONE BY A SPECIALLY
INSTRUCTED PERSON.
LASER DIODE CHARACTERISTICS ———
MAXIMUM OUTPUT POWER: 5 mW
WAVELENGTH: 780 - 785 nm
,