WABCO OnGuard Installation Instructions Manual page 4

8. Place the fascia in position over the radar sensor. Install
the M6 x 35 mm flange-head bolts included in the kit
and dry tighten to 91 in-lb (10.3 N∙m). Figure 8.
Figure 8
OnGuard Display Removal
®
1. Verify the ignition switch is in the OFF position.
2. In order to access the OnGuard display mounting
screws, you must remove the instrument panel
according to the vehicle manufacturer's recommended
procedure.
3. Once the instrument panel is removed, unscrew and
remove the OnGuard display screws, nuts and washers
from the back of the panel. Save the nuts and washers
for reuse during installation of the new display.
4. Disconnect the wiring connector from the OnGuard
display.
5. Remove the OnGuard display from the instrument panel.
OnGuard Display Installation
®
1. Connect the OEM display connector to the display
adapter harness by pushing on the connector end until
it snaps into the connector. Figure 9.
Figure 9
DISPLAY ADAPTER HARNESS
TP1368 / Revised 05.2020
Page 4
2. Install the new OnGuard display using the nuts and
3. Connect the display adapter harness to the new
Figure 10
FASCIA
4010734a
4. Reinstall the instrument panel according to the vehicle
5. Turn the ignition to the ON position and perform the
Radar Sensor Service Alignment
The Radar Not Aligned screen will be displayed as shown in Figure
11.
Figure 11
NOTE
While the OnGuard system is in Service Alignment mode,
OnGuard will not track vehicles or operate until the Service
Alignment procedure is completed.
1. Before starting the alignment procedure, visually verify
4010735a
washers from previous display.
OnGuard display. Figure 10.
manufacturer's recommended procedure.
Radar Sensor Service Alignment procedure in this
bulletin.
RADAR ALIGNMENT
Radar Not Aligned
Start Alignment Process
0%
that the radar sensor is not loose. To correctly inspect
the integrity of the radar mounting hardware, hold on to
the radar and wiggle it back and forth. There should not
DISPLAY
ADAPTER
HARNESS
4010736a
4010385a