Advertisement
TUNER
Press the POWER switch to the ON position.
Select TUNER with the input selector.
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadcasts.
Switch ON the SPEAKERS button corresponding to the speakers
being used.
TUNING INTO STATIONS
1
2 ri
20
90000
0/0
1. Tune into the desired station.
@ See the section "TUNING INTO STATIONS".
In addition to station frequencies, the MPX MODE
(AUTO/
MONO) can also be preset (FM only).
2. Press the MEMORY
button.
© The station number flashes in the display. (Memory mode)
3. Turn the TUNER
JOG
to select the station you
want to
memorize, and press the ENTER button.
@ The station number lights in the display, indicating that it has
been memorized.
© If you do not press the ENTER button within about five seconds
after selecting a station, the memory mode is canceled.
4. Repeat steps 1 to 3 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you store a
new preset, it takes the place of the previously stored station
(if any).
FM auto stereo reception and monaural reception
Each time you press the MPX MODE button, the MONO indicator
in the display section lights or goes out.
© If an FM stereo broadcast is received when the MONO indicator
is out, the STEREO indicator lights, and sound is in stereo.
if an FM stereo broadcast is received when the MONO indicator
is lit, the sound wil! be monaural.
If there is interference during STEREO mode reception, switch
to MONO. The sound will become monaural but interference
will be reduced.
1. Use the FM/AM button to select either FM or AM.
@ When the "ST. CALL" indicator is lit in the display, press the
SELECT button to switch it off.
2. Turn the TUNING
JOG until you reach the frequency of a
desired station.
When a station is received, the TUNED indicator will light up.
NOTE:
The TUNED indicator may not light with broadcasts received over
long distances, or when the broadcast signals are extremely weak.
3. Adjust the volume and tone as desired.
Auto tuning
Auto tuning is convenient
when you do not remember the frequency
of a desired station, or when you wish to find stations that you do not
normally listen to.
Operate by remote control. Refer to page 25.
LISTENING TO BROADCASTS USING
PRESET TUNING
1. Press the SELECT button.
The
"ST CALL" indicator lights in the display, and the mode
switches to station call.
2. Turn the TUNER JOG to select a station.
3. Adjust the volume and tone as desired.
NOTE:
Even if the receiver power cord is unplugged, data remains in
memory for a few days. If the contents of the memory are erased,
preset once more.
Last station memory
When the POWER switch is pressed to turn the power on, the last
station received before the power was previously turned off will be
tuned in again.
When the power is ON, if the BAND FM/AM button is pressed, the
last station received before the BAND FM/AM button was previously
pressed will be tuned in again.
17
<ARB1477>
F
e
N
e e
O
o n e e h
5
Advertisement
