Federal Communications Commission Compliance Information - Behringer U-CONTROL UCA202 User Manual

12
U-CONTROL UCA202 User Manual
USB 1.1
Connectors
Digital Processing
Converter
Sample rate
System Data
Frequency response
THD
Crosstalk
Signal-to-noise ratio
type A
16-bit converter
32.0 kHz, 44.1 kHz, 48.0 kHz
10 Hz to 20 kHz,
±1 dB @44.1 kHz sample rate
10 Hz to 22 kHz,
±1 dB @48.0 kHz sample rate
0.05% typ. @-10 dBV, 1 kHz
-77 dB @0 dBV, 1 kHz
A/D 89 dB typ.@
1 kHz, A-weighted
D /A 96 dB typ. @
1 kHz, A-weighted
Power Supply
USB connection
Dimensions/ Weight
Dimensions (H x W x D )
Weight
5V=, l00mAmax.
approx. 22 x 60 x 88 mm
(0.9
X
2.4
X
3.5")
approx. 0.10 kg (0.2 lbs)
BEHRINGER always takes great care to ensure the highest standard of quality. Any modifications
which may be necessary will be made without prior notification. Specifications and appearance
of the equipment can therefore differ from the details or illustrations shown.
13 U-CONTROL UCA202 User Manual
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
~BEHRINGER
~ U-CONTROL UCA202
Responsible Party Name:
Address:
Phone Number:
U-CONTROL UCA202
MUSIC Group Services NV Inc.
5270 Procyon Street
Las Vegas, NV 89118
USA
+
1 702 800 8290
complies with the FCC rules as mentioned in the following paragraph:
This equipm ent has been tested and found to comply with the limits for a
C lass B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection agai nst harmful interference in
a residential installation . This equ ipment generates, uses and ca n radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communication
However, there is no guarantee that interference will not occur in a
particular installation. If this eq uipm ent does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate th e receiving antenna.
• Increase the separation between the equipment and receiver.
• Con nect the equipment into an outlet on a circuit different from that t
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC ru les. Operation is su bject to
the following two conditions:
(1)
this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Important information:
Changes or modifications to the equ ipment not expressly approved by
MUSIC Group can void the user's authority to use the equipment.