Louis Tellier EX5 Instructions

Electric food mill

Advertisement

Technical characteristics

Model: EX5
Tension: 110 V
Frequency: 60 Hz
Nominal power: 600 W
Recommended intermittent cycle: 60 minutes of use / 60 minutes of rest
Output speed: 70 rpm
Attention
Any replacement of the electrical parts as well as the replacement of the power cord must be
carried out by authorized personnel.
Before switching on, make sure the protective grid is in place.

Cleaning and Maintenance

1. Disconnect the power cord before cleaning.
2. Do not hose down the motor assembly (wash with a damp cloth only )
3. Remove the cone/grid assembly from its support
4. Clean everything with soapy water
5. Wipe with a dry cloth

Remarks

 The grills of our manual appliances cannot under any circumstances be used on electrical appliances.
 When the appliance is new, the inside of the grill is very rough, which is a factor in efficiency.
 When the inside of the grill becomes smooth, it is necessary to replace it.

Warranty *

1 Year Parts & Labor
*The warranty does not cover repairs due to the following instances:
unintended use or misuse of the device
damages incurred by shock or fall
connection to a higher current than that indicated on the device
dismantling of the unit (other than what's permitted in the manual)
normal wear and tear
Instructions for electric food mill
Model # EX5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EX5 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Louis Tellier EX5

  • Page 1 Instructions for electric food mill Model # EX5 Technical characteristics Model: EX5 Tension: 110 V Frequency: 60 Hz Nominal power: 600 W Recommended intermittent cycle: 60 minutes of use / 60 minutes of rest Output speed: 70 rpm Attention Any replacement of the electrical parts as well as the replacement of the power cord must be carried out by authorized personnel.
  • Page 2 Setup (for better illustration, the safety grid does not appear on the following diagrams) Insert the motor assembly (A) into the square tube of Rotate the motor assembly (A) to the right. the foot (B) up to the stop ring (C). ...
  • Page 3 SWITCH BUTTON E5068 CONE EX5001 SHAFT (without central spring) EX5051 CROSSBAR – BUSHING – PROTECTION HOLDING SPRING EX5052 X5003 CENTRAL SPRING ANTI SPLASH P10003 CYLINDER EX5050  To disassemble the cone, press on the two hook springs to release the clasps. ...

Table of Contents