Kenwood TS-530SP Instruction Manual page 13

9. ANTI VOX CONTROL @®
Adjust the control to prevent speaker output from tripping
the VOX.
10. SPEAKER JACK ®
The receiver audio output can be connected through this
jack to an external 4 to 16 ohm speaker. The internal
speaker is disconnected when an external speaker is con-
nected.
11. EXTERNAL VFO CONNECTOR
This DIN connector is used to interface the KENWOOD
VFO-230 or VFO-240 external VFO. The interconnecting
cable is provided with the VFO.
PIN FUNCTION PIN
VFO signal
FUNCTION
VFO control
2 Relay control Display control
(+ on transmit)
3 +9V Ground
CW freq. shift control +12V
12. REMOTE CONNECTOR
This connector is used to interconnect a linear amplifier or
other accessory item. See page 24 for detail.
13. AC FUSE
This fuse protects the transmitter power supply against
short circuits. Never use a higher amperage fuse than spe-
cified; it will eventually cause extensive damage. If the
fuse blows, try to determine the cause before replacing.
For 110/120 volt operation use a 6 ampere fuse and for
220/240 volt operation, a 4 ampere fuse.
14, PREDRILLED HOLES F
These are provided for owner-installed switches or con-
nectors.
* VOLTAGE SELECTOR SWITCH
The 220/240 VAC or 120/220 VAC line model
(TS-530SP: for Europe) is equipped with a voltage selector
switch on the rear panel. Set this switch for your local line
voltage, as required.
For TS-530D
The 110/220 VAC line model is equipped with a voltage
selector switch on the rear panel. Set this switch for your
local line voltage, as required.
13