Do you have a question about the Elmo FP8-C and is the answer not in the manual?
Questions and answers
Ellie DiLapi
March 2, 2025
The light turns on but the motor does not. Can this be repaired? Near Philadelphia?
1 comments:
Mr. Anderson
March 2, 2025
The manual states that the motor should be lubricated by inserting oil into the two tubes above the bearings. If lubrication does not resolve the issue, the projector should be serviced by an authorized Honeywell repair center. The manual advises not to send the projector directly to Honeywell but to contact a Honeywell Photographic Dealer, who will select an authorized repair center for the fastest service. If you are near Philadelphia, you should locate a Honeywell Photographic Dealer in your area for repair options.
This answer is automatically generated
Ellie
March 1, 2025
How to fix motor that does not turn on.
1 comments:
Mr. Anderson
March 1, 2025
If the motor of a Honeywell Elmo FP8-C projector does not turn on, one possible cause could be dry motor bearings. The owner's manual recommends adding lubrication to the motor as part of regular maintenance. To fix this issue:
1. Ensure the projector is plugged in and the power switch is turned on. 2. Check if the motor switch is properly engaged. 3. If the motor still does not run, apply lubrication to the motor bearings as instructed in the manual. 4. Allow the lubricant to settle, then try turning on the projector again.
If the motor remains unresponsive, further inspection or professional servicing may be required.
Need help?
Do you have a question about the Elmo FP8-C and is the answer not in the manual?
Questions and answers
The light turns on but the motor does not. Can this be repaired? Near Philadelphia?
The manual states that the motor should be lubricated by inserting oil into the two tubes above the bearings. If lubrication does not resolve the issue, the projector should be serviced by an authorized Honeywell repair center. The manual advises not to send the projector directly to Honeywell but to contact a Honeywell Photographic Dealer, who will select an authorized repair center for the fastest service. If you are near Philadelphia, you should locate a Honeywell Photographic Dealer in your area for repair options.
This answer is automatically generated
How to fix motor that does not turn on.
If the motor of a Honeywell Elmo FP8-C projector does not turn on, one possible cause could be dry motor bearings. The owner's manual recommends adding lubrication to the motor as part of regular maintenance. To fix this issue:
1. Ensure the projector is plugged in and the power switch is turned on.
2. Check if the motor switch is properly engaged.
3. If the motor still does not run, apply lubrication to the motor bearings as instructed in the manual.
4. Allow the lubricant to settle, then try turning on the projector again.
If the motor remains unresponsive, further inspection or professional servicing may be required.
This answer is automatically generated