first cup of espresso.
a) Make sure the Selector Dial is in the middle position.
c) Fill the water container with fresh, cold water.
e) Make sure the thumbguard does not cover the sieve.
j) Empty the cups and remove the portafilter.
All parts are now pre-warmed.
6. Filling and Inserting the Portafilter
The one-cup sieve can also be used with espresso pods.
off the rim of the sieve and the portafilter.
* Insert and lock the portafilter (See chapter 5, f).
7. Preparing Espresso
d) When the desired amount of espresso is brewed, stop the flow by turning
the selector dial to the center position "e",
Note: It is normal for the green light to blink after brewing indicating the
thermoblock is heating the water for your next espresso.
Note: After stopping the flow of espresso, the EC100 automatically creates
a bit of steam and pushes the remaining water from the thermoblock into
the tray underneath. This ensures that there will be no rest-water in the
heating system. After preparing a few cups of espresso carefully pull the
tray out of the machine, empty and replace.
f) Remove the portafilter from the appliance.
9) Lift the thumbguard over the sieve and hold it down.
8. Preparing Cappuccino
Frothing Milk
>