Table of Contents
Advertisement
Before starting the generator, check to see that there is sufficient gasoline in the fuel tank. The fuel
gauge on top of the generator will indicate the fuel level in the tank. Add gasoline if necessary but
leave sufficient room in tank for expansion.
open flame can lead to explosion even if not directly in contact with fuel.
x Do not operate near open flame.
x Do not smoke near generator.
x Always operate on a firm, level surface.
x Always turn generator off before refueling. Allow generator to cool for at least 2
minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank.
x Do not overfill fuel tank. Gasoline may expand during operation. Do not fill to the
top of the tank. Allow for expansion.
x Always check for spilled fuel before operating. Clean up any spilled fuel before
starting.
x Empty fuel tank before storing or transporting the generator.
x Before transporting, turn fuel valve to off and disconnect spark plug cap.
IMPORTANT:
x Use only UNLEADED gasoline with an octane rating of 87 or higher.
x Do not use old gas.
x Never use an oil/gasoline mixture.
x Avoid letting dirt or water into the fuel tank.
Step 3- Ground the Generator
WARNING:
electrocution.
Ground the generator by tightening the grounding nut on the front control panel against a
grounding wire. (Figure 11) A generally acceptable grounding wire is a No. 12 AWG (American
Wire Gauge) stranded copper wire. This grounding wire should be connected at the other end to a
copper or brass rod that is driven into the earth. Wire and grounding rod are not included in
generator contents.
Grounding codes can vary by location. Contact a local electrician for area codes.
WARNING:
flammable and explosive gasoline vapors, which can
cause severe burns or even death if ignited. A nearby
Failure to properly ground the generator can result in
18
This generator may emit highly
Advertisement
Table of Contents
