OrangeRx GA800HV Instruction Manual

GABOOHV Instruction manual
1. INTRODUCTION
1.1 Compatibility:
FASST 2.4G Air Systems (?CH Mode/Multi Mode): 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, 14SG,
T12Z, T12FG, TM-14, T14MZ, etc.
FASST 2.4G Surface Systems (C1 Mode}: 3PK, 4PK, etc.
1.2 Specifications:
Operating Voltage Range: 3.5V- 8.4V
Dimension: 47.5X25.3X15mm
Weight: 11g
Latency: 14ms (FS)
?ms (HS)
1.3
Features:
1) Compatible with FASST 2.4G: Air Systems (?CH Mode/Multi Mode} & Surface Systems (C1 Mode};
2) Parallel with one more GASOOHV to become a 14 channel FASST compatible receiver;
3) Two selectable failsafe setting options;
4) Improve capability of anti-interference ;
5) Firmware upgradable
2. SETUP (BIND PROCEDURE I SETTING FAILSAFE I LED STATUS)
2.1 Bind procedure:
Turn on the transmitter, connect the battery to the receiver while pressing receiver's F/S button. After the RED LED is off
and GREEN LED is solid, the binding process is completed and the receiver is operating normally.
2.2 Setting failsafe:
GASOOHVsupport two selectable failsafe setting options, either use native failsafe position preset on the transmitter side, or
set failsafe on transmitter.
2.2.1 Use native failsafe position preset on the transmitter side:
If not disabling failsafe on the transmitter side,GASOOHV will use native failsafe position preset on the transmitter side.
2.2.2 Set failsafe on transmitter:
GASOOHV supports failsafe function for all channels. Follow the steps below to set failsafe on GASOOHV :
1) Bind the receiver first, and disable failsafe on the transmitter side;
2) Set all transmitter controls to the desired failsafe position;
3) Press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, indicating the failsafe is set
up successfully.
If you do not need the failsafe function any more, just re-bind the receiver to set default failsafe mode.
Hint: If not disabling failsafe on the transmitter side, GA800HV will use native failsafe position preset on the
transmitter side.