Zanussi DW 15 TCR Instructions For The Use And Care page 11

Electrical connections
WARNING: THIS APPLIANCE MUST
BE EARTHED. The manufacturer
declines any liability should this safety
measure not be obseiTed.
If the plug that is fitted to your appliance
is not suitable for your socket outlet, it
must be cut off and the appropriate plug
fitted.
The cut off plug should be disposed of to
prevent the hazard of elc:ctric shocks in
case it should be plugged into a 13 Amp
socket in another part of your home.
IMPORTANT:
The wires in this mains
lead are coloured in accordance with the
following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN-LIVE
If you fit your own plug, the colours of the
wires in the mains lead of your appliance
may not correspond with the markings
identifying the terminals in your plug, this
is what you have to do;
Connect the gi'een and yellow (earth) wire
to the terminal in the plug which is
marked with the letter «E» or the earth
symbol 0,or coloured gi'een, or green and
yellow.
Connect the blue (neutral) wire to the
temiinal in the plug which is marked with
the letter «N» or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
«L» or coloured red.
The plug moulded on to the cord
incorporates a fuse. For replacement use a
13 Amp BS 1362 fuse. Only ASTA
approved fuses should be used.
The fuse cover/carrier must be replaced
in the event of changing fuse.
The right fuse cover/carrier colour is the
one shown by the coloured insert at the
base of the plug or is the colour of the
inscription at the base of the plug.
The plug must not be used if the fuse
cover/cairier is lost
A replacement cover/carrier must be
obtained from Zanussi Service Agents
whose addresses are listed on the
attached «Zanussi Service and Spares
Nationwide)).
THIS APPLIANCE COMPLIES WITH
E.E.C. DIRECTIVE NO. 82/499 OF 7.6.82
RELATIVE TO RADIO
INTERFERENCE SUPPRESSION.
11