Table of Contents
Advertisement
IMPORTANT!
POWER ON...
CHECKING PLAYBACK...
Figure 8. Located on each OVTR I's
rear panel are a BASS level control
and a dual-color "Power On" LED.
.
Compositions Overture OVTR 1 -
OPERATING THE SYSTEM
Each Compositions Overture OVTR 1 speaker system contains a built-in
powered subwoofer. For your convenience, the system is not fitted with a
power on/off switch. Instead, an auto-sense circuit will instantly switch
the system on when an audio signal is present, and will automatically
revert to standby (drawing only 7 watts) when audio is absent for a
minimum of 10 minutes. A dual-color "Power On" LED (see Figure 8
below) glows red when the amplifier is the stand-by mode and green
when the amplifier is on.
If on/off switching is desired, connect the OVTR 1's ac power cord to an
ac switched outlet. If you plan to leave for an extended period of time
(e.g., vacation), switch the system off (or unplug the ac power cord).
This product is designed for (USA) 120 Vac use only. Do not connect it to
any other line voltages.
1. After speaker wiring has been completed, connect each speaker's ac
power cord to the nearest ac receptacle. You should see an LED
illuminate, indicating the amplifier is on (see Figure 8 below). If not,
verify the ac outlet is delivering power or refer to Troubleshooting
2. Check the speakers for playback by first setting the audio system
volume control for a minimum level, and then applying power to your
system. Play a favorite music or video segment and increase the
volume control to a comfortable level.
NOTE: You should hear balanced audio reproduction across the
entire frequency spectrum. If not, check all wiring ConmechOls and
refer to the "Troubleshooting" section
et
e e
ee
oO |
ce)
MAX
MIN
Oo
o
More C)
Less
Bass
>
Bass
e
o
BASS CONTROL
ON / STANDBY
Power On CS Stand-By
is green
is red
"POWER ON" LED
OVTR 1
OVTR 1
°
(rear view)
°
Advertisement
Table of Contents
