Summary of Contents for TEMPLE & WEBSTER build TBR44PS
- Page 1 Heated Towel Rail Installation Instructions Please read these instructions carefully before installation. Hardwire Installation should be carried out by a qualified electrician...
- Page 2 Check you’ve got everything: Exposed Wiring Mounting Bracket x 1 Exposed Wired Leg x 1 Mounting Bracket Allen Key Countersunk Wall Plug x 4 Screw x 4 Concealed Wired Leg x 2 Machine Screw Grub Screw White Concealed Wiring x 10 (in legs) Sleeve Non –...
- Page 3 Concealed Wiring Installation Collect the parts you need Ensure that you have all the correct parts needed for concealed wiring installation of this towel rail. Any additional parts that are for exposed wiring will not be required. Fix the legs to the rail First, decide which side you want to connect the electrical supply to and then allocate the appropriate legs to each of the three remaining mounting points.
- Page 4 Install the Wall Brackets Drill a 6mm hole in the centre of each of the four marked mounting positions and insert the wall plugs provided into the three non-wired legs. Now fix the three wall brackets in place using the countersunk screws and a cross head screwdriver.
- Page 5 Exposed Wiring Installation Collect the parts you need Ensure that you have all the correct parts needed for exposed wiring installation of this towel rail. Any additional parts that are for concealed wiring will not be required. Fix the legs to the rail First, decide which side you want to connect the electrical supply to and then allocate the appropriate legs to each of the three non-wired remaining mounting points.
- Page 6 Install the Wall Brackets Drill a 6mm hole in the centre of each of the four marked mounting positions and insert the wall plugs provided. Now fix the three wall brackets in place using the countersunk screws and a cross head screwdriver. In the fourth position attach the exposed wiring mounting bracket using a countersunk screw.
- Page 7 Safety Information Heated Towel Rails should be installed by a qualified electrician and in accordance with current local regulations. We recommend that the rail is installed onto a flat uniform wall at with a 300mm clearance from permanent fixtures. Where possible the Heated Towel Rail should be screwed into studs or if fixing to hollow walls suitable anchors should be used to ensure rail is secure.
- Page 8 Care Information The finish of your Heated Towel Rail is hard-wearing and easy to maintain. However, any harsh scrubbing, scratching or acid-based cleaning products will damage the surface of your towel rail. Cleaning with a soft cloth and a non- abrasive cleaning agent will give the best results.
Need help?
Do you have a question about the build TBR44PS and is the answer not in the manual?
Questions and answers