Download Print this page

Data Signs RF REMOTE Manual

Download this manual

RF Remote Manual

Page 1 RF Remote Manual...
Page 2 Best use of the PTL RF Remote RAISE TO WAKE CHANGE LOWER LIGHTS TO SLEEP Proper operation for the PTL-Remote is to use the lanyard. This will prevent the operator from dropping and damaging the unit and allow good operational process.
Page 3 RF Remote for Type-2 use The Optional Remote is used by the operator to control traffic flow when the Master Controller has been set to Channel: 8 Total Units: 2 Manual mode. It is recharged M: PTLN2 S1: PTLN1 by placing it in the cradle in...
Page 4 When the battery on the Remote Control gets low, a warning message will appear on the display panel. To recharge the Remote Control, plug it into the remote cradle in the Control box on the Master unit and connect the charge cable.
Page 5 Setting the RF Channel on the Remote THE REMOTE MUST BE SET TO THE SAME CHANNEL AS THE MASTER PTL CONTROLLERS To set the RF Channel on the Remote Control, follow these instructions. 1. Press the button on the bottom/left of the MENU screen to go to settings.