Page 1
Version 06 / 15.05.2023 HIT-TRAC 8B HIT-TRAC 8A HIT-TRAC 8B HIT-TRAC 8A Jakob AG Dorfstrasse 34 3555 Trubschachen Switzerland +41 (0)34 495 10 10 +41 (0)34 495 10 25 info@jakob.ch jakob.com jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 1 / 21...
Page 2
Confermiamo che la macchina menzionata è stata controllata e che è conforme, sotto ogni aspetto, ai requisiti di incarico, alle specifiche, ai disegni nonché alle norme e alle disposizioni. Macchina motorizzata con comando a cavo flessibile HIT-TRAC 8B con motore a benzina Macchina motorizzata con comando a cavo flessibile HIT-TRAC 8A con motore a batteria Geräte Nr.
2.7.5 Inserting rope ................................. 11 Working ..................................11 2.8.1 Pulling and lifting ..............................11 2.8.2 Restart under load HIT-TRAC 8B ..........................12 2.8.3 Lowering ................................. 12 Decommissioning ............................... 12 2.10 Storage and transport ..............................12 Design and function ................................13 Technical specifications ..............................
Page 4
Preface You made a good choice when you selected the Jakob AG HIT-TRAC motor-driven rope pulling machine. This state of the art rope pulling machine allows you to pull, lift and lower loads. Operation and maintenance are very simple and with correct handling ensure trouble-free and reliable operation.
Page 5
Stv. Leiter Technik Leiter Seil- & Hebetechnik Suppléant du chef technique / deputy Head of Technology Chef câbles et levage / Head of Hoisting and Lifting Thomas Gerber Urs Schneider jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 5 / 21...
Wear ear defenders Intended use The HIT-TRAC motor-driven rope pulling machine is designed to pull, lift and lower loads. The HIT-TRAC must not be used to transport persons. jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 8 / 21...
Warranty and liability provisions The liability and warranty provisions of the general T&C of Jakob Rope Systems apply. Especially T&C points 10 and 11. Behavior in an emergency situation Before starting work, always inform yourself whether and where there is a mobile phone network or where a traditional tele- phone is available.
During operation, ensure that the machine is not standing directly in water (or snow). Following contact with water, you should have your HIT-TRAC checked by Jakob AG so that the brakes can be dried and greased. If the brakes are wet, the load can either not be lowered or can only be lowered jerkily.
If the brake release lever (25) is not swivelled upwards, the load will fall at lowering speed after the throt- tle lever (32/37) is released. Pivot brake release lever (25) upwards immediately Wear ear defenders when working with the machine! jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 11 / 21...
This phenomenon is therefore operational. The machine operation can be continued with- out hesitation. 2.8.2 Restart under load HIT-TRAC 8B Allowing the coupling to slide through for too long leads to overheating and early wear and tear. 2.8.3 Lowering In an emergency Release throttle lever (32/37).
End of charge voltage 42 V Charging time 80% 30 min Charging time 100% 45 min Quick charger AL 500 Rated voltage 220-240 V Charging current 12 A Weight 1.3 kg jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 13 / 21...
The motor does not allow braking. The load is stopped using a brake which is built into the machine which needs to be re- leased by hand for lowering. jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 14 / 21...
Technical anchor points: - Habegger field anchor with posts - Rock anchor, concrete anchor - Round wood anchor in ground - These anchors depend very much on the ground conditions. jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 15 / 21...
7. On loose rope and (2) pull the rope into the rope groove of the drive wheel (9). 8. Check correct location of rope one more time. 9. Close housing cover (11) and lock with cover handle (12). jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 17 / 21...
80 m If the load is to be lowered over longer distances, the brake should be allowed to cool (air) and then lowered the rest of the distance. jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 18 / 21...
Release machine from the anchor point Storage and transport The device must be stored in a dry place. During transport and storage, the device must be covered against dust. jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 19 / 21...
The tension in the rope cannot be Brake not released Release brake by pivoting brake re- relieved lease lever (25) backwards Brake wet Have machine repaired Chain brake (38) engaged Release chain brake (38) jakob.com ∙ info@jakob.com ∙ Copyright by Jakob AG Switzerland 20 / 21...
In addition to this additional tests must be arranged by an expert according to the local regula- tions as well as after harsh use conditions, at a shortened interval. Spare parts The spare parts are provided on a separate list. This can be requested from Jakob AG. Disposal Please comply with the local regulations on disposal.