Safety Warning - Telefunken U47 Operator's Manual

Quick Start Guide
1. Thread the included shock mount on to a sturdy microphone stand. Double
check that the stand is stable and properly balanced; falls from microphone
stands can require costly repairs.
2. Set the microphone into the shock mount and fasten the latches.
3. Insert the cable into the base of the microphone and begin threading it on. If
you experience resistance, reverse the threading direction and make sure the
connector is inserted correctly.
4. Plug the other end of the microphone cable into the included power supply.
It is recommended that the power supply be at least 3 meters from the
microphone while recording. Make sure the cable is kept close to the stand and
ground to avoid tripping or knocking over the microphone.
5. Make sure the power supply is set to the correct mains voltage for your region
(115V or 230V). Plug the included power cable into the power supply, then into
mains power.
6. Connect a standard 3-pin microphone cable (not included) to the power
supply and then to your microphone preamplifier input.
7. Turn on the power supply. Let the system warm up for 10 minutes before use.

Safety Warning

Vacuum tube microphones, their associated power supplies, and their cables
carry potentially harmful voltages. Make sure all connections are made before
powering on your microphone system. Do not open your microphone or power
supply while it's connected to mains power and powered on. If for whatever
reason your Diamond Series microphone stops working, turn it off and contact
an authorized TELEFUNKEN repair center.
4 TELEFUNKEN Elektroakustik
Handling
Handle your microphone, cable, and power supply with the utmost care.
Remember that Diamond Series microphones are reverse engineered from
vintage models, so most mechanical parts are custom machined and not
cheaply or easily replaceable. If damage occurs or there is a change in
operation, please contact TELEFUNKEN directly at repairs@t-funk.com.
Storage
When not in use, store your microphone in the included wooden box. It is not
recommended to leave your microphone on a stand. Not only will dust degrade
the response of the capsule over time, but this greatly increases the risk of a fall,
which could result in required mechanical repair or cosmetic damage.
Properly coil your tube microphone cable when storing. Kinks left in the cable
will expedite the deterioration of the conductors which will lead to shorts or
opens in crucial contacts, and ultimately failure.
Cleaning
To clean fingerprints and light grime from your microphone, wipe with a soft
cloth damp with an ammonia-based glass cleaner as soon as possible. We use
microfiber cloths, but any soft, lint-free cloth will do. Spray the cleaner onto the
cloth first. Never spray any liquid directly onto your microphone.
To lubricate your threaded cable collar, apply a small amount of electronics
cleaner/lubricant (we use DeoxIT Gold) with a cotton swab. Do not spray the
lubricant directly into the cable connector.
Never attempt to clean your microphone capsule. This should only be
performed by a reputable, trusted professional. It is recommended to contact to
TELEFUNKEN to have this service performed.
If you have any questions regarding cleaning your microphone or having these
services performed by a TELEFUNKEN technician, please contact repairs@t-
funk.com.
Diamond Series 5