Advertisement
Reassembly of the Model
262
Movement
DAY I DATE
FRAME
BOSS
HOLE
BOSS
HOLE
After the basic movement has been
cleaned and
lubricated
following the
procedures for the Model 260, the
Model 262 movement is reosseml-;led
in order as follows
:
Day Detent Spring':'
Dote Detent Spring':'
Center Wheel Assembly
Hour Wheel Assembly
Hour Wheel Washer
Dote Wheel
Assemble Day /Dote Frome (note two
bosses on bock of frame)
engage
bosses in corresponding holes in the
Dial Rest, Position Dote Wheel with
tabs located as shown in illustration
at the
left.
··· Lubricate bearing surface of both
detent springs with small amount
of non-spreading watch oil ( Moeb-
ius Synt-A-Lube is used in the
facto ry)
.
262 .7
Advertisement
