Table of Contents
Advertisement
SECTION 8: ADJUSTMENTS
_b
ARNING: Do not at any time
make any adjustment
to lawn mower
without
first
stopping engine and disconnecting spark plug wire.
Cutting
Height
Adjustment
Lever
Figure 8
An adjusting plate and thumb lever at each wheel position provides cutting height adjustment.
Each
adjusting plate has nine height positions. Height of cut will be changed when the thumb lever is moved
from one hole to another. Simply depress the lever towards wheel and move wheel and lever assembly
to desired position. All wheels must be placed in the same relative position. See Figure 8.
For rough or uneven lawns, move the height adjustment
handles to positions which will give a higher
cutting height. Both front and rear handles must be placed in the same relative position.
Handle
Height Adjustment
Lower Handle
Notch
Figure 9
Your mower is shipped with the handle in the higher height position, To tower the handle height, proceed
as follows.
• Remove the starter rope from the rope guide.
• Remove the upper handle by removing the hand knobs and carriage bolts. Lay the upper handle
out of the way, being careful not to bend or kink the cables.
10
Advertisement
Table of Contents
