Advertisement
Quick Links
This Roof Rack design has been verified to the
guidelines stated in this document for use on recreation
vehicles.
SERVICE CALLS & QUESTIONS
Location and phone numbers of qualified Service
Centers
can
be
http://www.atwoodmobile.com
locate a Service Center.
SAFETY ALERT SYMBOLS
Safety Symbols alerting you to potential personal safety hazards.
Obey all safety messages following these symbols
WARNING
avoid possible
injury or death
MAY CAUSE PERSONAL INJURY OR DEATH
For your safety and protection, it is important that this
installation manual is read and understood before
installation or use. Failure to properly install the unit or
attempting to modify it in any way can be extremely
hazardous and may result in property damage and
personal injury and will void the warranty.
MAY CAUSE PERSONAL INJURY OR PROPERTY
DAMAGE
Incorrect or improper installation may cause
personal injury and/or property damage.
found
at
our
or call 866-869-3118 to
CAUTION
avoid possible
damage
injury and/or property
WARNING
CAUTION
Installation
Package Contents:
website
• Side Rails with Insert: Quantity 2
• Center Rail with Insert: Quantity 1
• Center Rail: Quantity 1
• 4" Stanchion: Quantity 7
• #8 x 3/4" Screw: Quantity 3
• Instruction Sheet: Quantity 1
Tools Required:
• Tape Measure
• Phillips-tip screwdriver (Screw gun recommended)
• Hacksaw or tube cutter (if alterations are required)
• File (if alterations are required)
This product is designed for installation onto the roof of
an RV. It provides additional structure, converting the
applied area into a storage alternative, expanding the
vehicle's storage capacity.
-The
MAXIMUM
determined by the design of the roof surface and
related substructure and will vary based on vehicle
design
manufacturer for this guideline.
LITERATURE NUMBER 297-333472
Roof Rack for
Recreational Vehicle
Operation
GENERAL INFORMATION
PURPOSE
WEIGHT
CAPACITY
and
manufacturer.
Model # MHR212
Maintenance
Effective 01/16/2014
will
be
Consult
the
RV
Advertisement
Related Manuals for Atwood MHR212
Summary of Contents for Atwood MHR212
- Page 1 LITERATURE NUMBER 297-333472 Roof Rack for Recreational Vehicle Model # MHR212 This Roof Rack design has been verified to the Installation Operation Maintenance guidelines stated in this document for use on recreation Effective 01/16/2014 vehicles. GENERAL INFORMATION SERVICE CALLS & QUESTIONS...
-
Page 2: Installation
Before you begin… INSTALLATION How to mount the Roof Rack to your RV roof. CAUTION WARNING MAY CAUSE PERSONAL INJURY OR PROPERTY DAMAGE MAY CAUSE PERSONAL INJURY OR DEATH It is the responsibility of the installer to inspect the RV roof to determine its condition and its rated capacity The Roof Rack is intended to be a permanent fixture. - Page 3 top of the second rail to align, mark and cut the second stanchions have an open side and should be oriented so rail. File the cut edges and replace the end cap on the all side openings face the center of the rack. Slide 3 second side rail.
-
Page 4: Operation
up over the tube seam where both pieces of the center OPERATION rail are joined. Once secured, fasten the other 2 center rail stanchions not more than 3” from the end of the center rail, but the same distance, on both sides; like the center stanchion, the end stanchions may also be used CAUTION to cover the tube seam between the side rails and the... -
Page 5: Maintenance
For the remainder of this document Atwood Mobile Roof Rack side bars or the Roof Rack rear bar. Use Products LLC will be referred to as Atwood. Atwood’s liability hereunder is limited multiple tie-downs to secure the items tightly within the to the replacement of the product, repair of the product, or replacement of the product with a reconditioned product at the discretion of the manufacturer.