Troy-Bilt TB25CE Operator's Manual page 5

This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's
manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
• SAFETY ALERT SYMBOL
Indicates danger, warning or caution. May be used in
conjunction with other symbols or pictographs.
• READ OPERATOR'S MANUAL
WARNING:
manual(s) and follow all warnings and safety
instructions. Failure to do so can result in serious
injury to the operator and/or bystanders.
• WEAR EYE AND HEARING PROTECTION
WARNING:
noise can cause severe eye injury and hearing loss.
Wear eye protection meeting current ANSI / ISEA
Z87.1 standards and ear protection when operating
this unit. Use a full face shield when needed.
• WEAR FOOT PROTECTION
Always wear heavy-duty, non-slip footwear when
operating this unit.
• WEAR HAND PROTECTION
Always wear heavy-duty, non-slip gloves when
handling this unit.
• HANDLE POSITION
Make sure the handle is positioned beyond the end of
the safety label.
• UNLEADED FUEL
Always use clean, fresh unleaded fuel.
• OIL
Refer to operator's manual for the proper type of oil.
• DO NOT USE E85 FUEL IN THIS UNIT
CAUTION:
containing greater than 10% ethanol will likely
damage this engine and void the warranty.
• SAFETY & INTERNATIONAL SYMBOLS •
Read the operator's
Thrown objects and loud
It has been proven that fuel
SYMBOL MEANING
• ON/OFF STOP CONTROL
ON / START / RUN
• ON/OFF STOP CONTROL
OFF or STOP
• PRIMER BULB
Push primer bulb, fully and slowly, 10 times.
• THROWN OBJECTS CAN CAUSE SEVERE INJURY
WARNING:
propelled at high speed, causing injury.
• KEEP BYSTANDERS AWAY
Min. 50 ft
WARNING:
especially children and pets, at least 50 feet (15 m)
15 m
from the operating area.
• HOT SURFACE
WARNING:
or cylinder. You may get burned. These parts get
extremely hot from operation. When turned off, they
remain hot for a short time.
• SHARP BLADE
WARNING:
the cutting head shield. To prevent serious injury, do
not touch the line cutting blade.
• DO NOT REPLACE CUTTING HEADS WITH BLADES*
WARNING:
prevent serious injury, do not replace the cutting head
with rigid or metal blades.
*This warning does not apply to units equipped with
blades, such as edgers and brush cutters.
• ROTATING BLADE CAN CAUSE SEVERE INJURY
WARNING:
blade to stop before replacing the blade, cleaning or
performing any maintenance. Keep hands and feet
away from moving parts.
5
Small objects can be
Keep all bystanders,
Do not touch a hot muffler
There is a sharp blade on
When using a trimmer, to
Stop the unit and allow the