Panasonic EY0214 Operating Instructions page 2

IMPORTANT SAFETY
INSTRUCTIONS
» SAVE THESE IN-
TRUCTIONS m
manual contains important safety and
operating Instructions for battery
charger EY0214.
2) Before using battery charger, read ail
instructions and cautionary markings
on (1) battery charger, (2) battery
pack.
3) CAUTION -To reduce the risk
of injury, charge only Battery Pack as
shown below.
EY9103, EY9101, EY9001, EY9006,
EY9180, EY9080, EY9182, EY9086,
EY9065, EY9106, EY9107, EY9136,
EY9117, EY9230, EY9200, EY9108,
EY9210
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger to rain or
snow.
5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or
stress.
7) An extension cord should not be
used unless absolutely necessary.
Use of Improper extension cord could
result in a risk of fire and electric
shock. If extension cord must be
used, make sure:
a. that pins on plug of extension cord
are the same number, size and
shape as those of plug on charger.
b. that extension cord is properly
wired and in good electrical
condition.
c. that wire size is targe enough for
ampere rating of charger as specified
below.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORD:
BATTERY CHARGERS
than
S FOR
AC Input Rating. Amperes AWG Size of Cord
Equalto or Butless Length ol Cord, Feet
25 650 100 150
16
greater than
0 2 18 18 18
8) Do not operate charger with
damaged cord or plug—replace them
immediately.
9) Do not operate charger if it has
received a sharp blow, been
dropped, or otherwise damaged in
any way; take it to a qualified
serviceman.
10) Do not disassemble charger; take it
to a qualified serviceman when
service or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or
cleaning.
12) The charger and battery pack are .
specifically designed to work
together. Do not attempt to charge
any other cordless tool or battery
pack with this charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the
battery pack housing.
15) Do not store the tool and battery
pack in tocations where the
temperature may reach or exceed
122°F (50°C) (such as a metal tool
shed, or a car in the i
can lead to deterioration of the
storage battery.
16) Do not charge battery pack when the
temperature is BELOW 32°F (0°C) or
ABOVE 104°F (40°C). This is very
important.