Soft Water Service - Sears SOLID STATE 625.348320 Owner's Manual

SECTION 2
HOW YOUR WATER SOFTENER WORKS
2B. SOFT WATER SERVICE AND REGENERATION
[] BRINING: During brining, the brine is moved
from the salt storage area, into the resin tank.
Inside the resin tank, brine cleans hardness
minerals from the resin beads and they are
discharged out the drain. How much brine is
needed to clean the resin depends on:
-- the amount of resin in the softener.
-- how fast the brine goes through the bed.
The nozzle and venturi (FIG. 9) makes the suction
to take brine fi'om the salt tank and put it into the
resin tank. It keeps the brine flow down to a very
slow rate to get the best resin cleaning with the
least salt.
[3-]BRINE RINSE: After all of the brine goes into
the resin tank, the brine valve closes. Water keeps
flowing the same way it did during brining, except
the brine flow has stopped. Hardness minerals
and brine flush from the resin tank to the drain.
WATER FLOW THROUGH THE
SOFTENER IN BRINING AND
BRINE RINSE
Hard Water
IN
Hard Water.
Nozzle Drain
Venturi
Brine Valve
Brine
I_]BACKWASH: During backwash, water flows
UP through the resin tank (FIG. 10) at a fast rate to
flush iron minerals, dilx and sediments from the
bed and to the drain. The bed lifts and expands for
good cleaning.
WATER FLOW THROUGH THE
SOFTENER IN BACKWASH
Hard Water
IN
Hard Water
BYPASS
Drain
bee
and expa
[]FAST RINSE: Backwash is fbllowed by a fast
flow of water down through the resin tank. The
fast flow packs the resin bed and gets it ready for
return to service (FIG. 11).
After fast rinse, the softener returns to service.
Hard water goes into the resin tank where the
resin bed again takes out the hardness minerals.
Soft water goes to the house soft water pipes.
WATER FLOW THROUGH THE
SOFTENER IN FAST RINSE
Hard Waler
IN
Soft Water
OUT _-_1 _f ii3i" Drain
12