Hisense FV14D6CWD User's Operation Manual page 6

Leveling of appliance
For sufficient leveling and air circulating in
the lower rear section of the appliance, the
bottom feet may need to be adjusted. You
can adjust them manually by hand or by
using a suitable tool.
Tools you will need:
Not provided
To allow the doors to self-close, tilt the top
backwards by about 10mm.
You can adjust them manually by hand or
using a suitable spanner.
Note:
 If required you may lay the refrigerator on
its back in order to gain access to the base,
you should rest it on soft foam packaging or
similar material to avoid damaging the
backboard of the refrigerator.
 There is no need to install these
accessories under normal usage.
Only under the extreme circumstances, that
is opening the door about 90 degrees, this
refrigerator may take risk of tipping.
Then rubber supporting pad should be
fastened to the lower base cover to steady
this appliance.
Philips Screwdriver &
Slotted Screwdriver
6
1. Tilt appliance to find screw hole on the
left of lower base cover.
2. Put screw into the hole of rubber
supporting pad.
3. Make screw in alignment with the hole on
lower base cover. Fasten rubber supporting
pad to the base cover firmly by a cross
screwdriver (self-provided).