Bmw Integral Abs - Troubleshooting Chart - BMW K 1200 LT 2005 Rider's Manual

BMW Integral ABS - troubleshooting chart

Warning light, ABS warning
general e light l
OFF ON
OFF Flashes at
1 Hz
OFF Flashes at
4 Hz
ON OFF
ON Flashes at
1 Hz
ON Flashes at
4 Hz
Alternate Alternate
flashing at flashing at
1 Hz 1 Hz
Alternate Alternate
flashing at flashing at
4 Hz 4 Hz
Malfunctions
Only RESIDUAL BRAKING FUNCTION
available in both circuits (
ABS not available
Pull-away test not completed (
Only RESIDUAL BRAKING FUNCTION
available in both circuits (
Self-diagnosis not completed (
Rear/brake light defective
( Maintenance Instructions, Chapter 2)
b
cruise-control system not available
At least one brake circuit without ABS
( 90)
b
At least one brake circuit in RESIDUAL
BRAKING FUNCTION mode (
Fluid level in BMW Integral ABS too low.
Check the motorcycle as follows:
– Ignition OFF: is brake pressure OK at
the brake levers?
– Are the brakes acting on both wheels?
– Is the brake system leaktight, no signs
of brake fluid escaping?
The brake system is defective if the test
outcome is negative.
Fluid level in the BMW Integral ABS is too
low, perform the checks listed above.
Only RESIDUAL BRAKING FUNCTION
available in at least one circuit (
d
Warning:
Do not ride the motorcycle if you have
any doubts about the dependability of
the brake system.
87)
b
88)
b
87)
b
88)
b
87)
b
87)
b
3
91