AEG OKO-LAVAMAT 72760 User Information page 26

Operating Instructions
If RINSE HOLD was selected:
If a programme finishes with RINSE HOLD, the indicator next to the
START/PAUSE button will flash.
0 1. After a rinse hold, the water must first be drained:
– Press either the START/PAUSE button
(the water is drained and the washing is spun in accordance with the
finished programme; the number of spin revolutions can still be al-
tered during the spin cycle using the spin revolution/RINSE HOLD
button),
or
– Turn the programme selector to OFF, and then to PUMP, and press the
START/PAUSE button
(the water will be drained without the spin cycle taking place),
or
– Turn the programme selector to OFF, and then to SPIN or SHORT SPIN,
and press the START/PAUSE button
(the water will be drained and the washing is spun or briefly spun).
After this programme cycle is complete, the END indicator illuminates.
The wash programme is complete.
2. Open the door and remove the washing.
3. Turn the programme selector to OFF.
If the EASY IRON programme was selected:
With EASY IRON, a crease prevention cycle of approx. 30 minutes takes
place after the programme is complete. The multi-display shows the
time remaining (e.g. 1 minute) and the END indicator iluminates.
You can remove the washing at any time during the crease prevention
cycle.
1. To do this, press the START/PAUSE button.
0
The door can now be opened and the washing removed.
2. Finally, turn the programme selector to OFF.
The wash programme is complete.
If the display OVER DOSING lights up, too much
3
washing detergent was used in the washing program
just ended. During the next wash, pay attention to
the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!
Attention! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains. (The Aqua Control water protection does not function
if the power supply is interrupted).
26