Pioneer SA-9800 Operating Instructions Manual

STEREO AMPLIFIER
@Q PIONEER'
Ss
A=-93800 "a
HG
OPERATING INSTRUCTIONS
These operating instructions are based on the model HG,
and they can be used for the S, 8/G models. The differences
between the models are given below.
Power requirements
SA-9800/HG
SA-9800/S, 8
220V/240V (switchable), 50Hz, 60Hz
110V/120V/220V/240V (switchable),
50Hz, 60Hz
NOTE:
Read through the section on the LINE VOLTAGE SE
LECTOR SWITCH on page 5 before using your amplifier
and check that the voltage selector switch is set correctly
for use in your area.
Power cords
SA-9800/HG; This is configured as an AC inlet type.
Use a separate power cord in order to
connect the power supply.
SA-9800/S, S/G: The power cord is mounted at the
rear.
Cabinet
SA-9800/HG, S:
SA-9800/S/G;
Others
SA-9800/HG:
Black cabinet
Walnut grained finished cabinet.
The DIN-type recording/playback
socket is provided on the rear panel
The AC outlets are provided on the
rear panel.
SA-9800/S, S/
Pe MPORTANT
To prevent electric shock, do not remove cover. No user
serviceable parts inside, refer servicing to qualified serv-
ice personnel.
Always disconnect all the equipment from the mains
supply when disconnecting the signal leads, The power
cord should be connected last, make sure that the power
switch is off. First, insert the female appliance connector
of the mains cord into the AC INLET, then plug the
cord to the wall socket, Be sure that the appliance con
nector is fully inserted into the AC INLET.
Unplug the set from the wall socket when it is not to be
used for an extended period of time,
WARNING
THIS APPARATUS MUST BE EARTHED.
FOR YOUR SAFETY
1, Insert this piug only into effectively earthed three-pin
plug-socket outlet.
2. If any doubt exists regarding the earthing, consult a
qualified electrician,
[ 3, Extension cords, if used, must be three-core correctly
wired.
—
FOR USE IN UNITED KINGDOM AND
AUSTRALIA
CAUTION 240V: Mains supply voltage is facto-
ry adjusted at 240V.
FOR USE IN UNITED KINGDOM
The wires in this mains lead are coloured in accordance
with the following code:
Green-and-Yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this ap-
paratus may not correspond with the coloured marking
identifying the terminals in your plug proceed as fol-
lows,
The wire which is coloured green-and-yellow must be
connected to the terminal which is marked with the let-
ter E or with the safety earth symbol 2 or coloured
green or green-and-yellow,
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or colour-
ed black,
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or colour J
ed red,