Table of Contents
Advertisement
Quick Links
TM
Omnical
2010
TM
Omnical
2010 Voltage Calibrator
Voltage calibrator
INSTRUCTION MANUAL
Serial No._____________________
B05F
World Precision Instruments, Inc.
International Trade Center • 175 Sarasota Center Boulevard • Sarasota FL 34240-9258 USA
Telephone: 941-371-1003 • FAX: 941-377-5428 • E-mail: wpi@wpiinc.com
UK: Astonbury Farm Business Centre, Astonbury, Stevenage, Herts SG2 7EG UK • Tel: 0438-880025 • FAX: 0438-880026 • E-mail: wpi@wpiuk.demon.co.uk
Germany: Liegnitzer Str. 15 D-10999 Berlin, Germany • Tel: 030-6188845 • FAX:030-6188670 • E-mail: 100604.2573@compuserve.com
5
WORLD PRECISION INSTRUMENTS
Japan: 1-4-2 Naka-Meguro, Meguro, Tokoyo 153, Japan • Tel: 03-3760-5050 • Fax: 03-3760-5055 • E-mail: 71124.2173@compuserve.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for WPI Omnical 2010
- Page 1 Telephone: 941-371-1003 • FAX: 941-377-5428 • E-mail: wpi@wpiinc.com UK: Astonbury Farm Business Centre, Astonbury, Stevenage, Herts SG2 7EG UK • Tel: 0438-880025 • FAX: 0438-880026 • E-mail: wpi@wpiuk.demon.co.uk Germany: Liegnitzer Str. 15 D-10999 Berlin, Germany • Tel: 030-6188845 • FAX:030-6188670 • E-mail: 100604.2573@compuserve.com WORLD PRECISION INSTRUMENTS Japan: 1-4-2 Naka-Meguro, Meguro, Tokoyo 153, Japan •...
- Page 2 Omnical 2010 Voltage Calibrator Introduction Omnical™ 2010 is a battery operated source of DC voltage and square waves electrically isolated from ground. A digital panel voltmeter accurately indicates the amplitude of the instrument's output voltage. By applying an external positive command voltage, the user may also obtain a gated DC voltage or trigger a single pulse.
- Page 3 Omnical 2010 Voltage Calibrator Operation DC Voltage Set the MODE switch to DC and switch the Power switch to ON. Depending on whether volts (V) or millivolts (mV) has been toggled on the Range switch, the digital voltmeter will indicate volts or millivolts respectively. Rotate both the COARSE and the FINE amplitude controls.
- Page 4 Omnical 2010 Voltage Calibrator Batteries Omnical™ 2010 is powered by two 9 volt alkaline batteries. Batteries should be replaced every six months or as needed. Battery fatigue is shown by the LO BAT indicator on the panel meter face or when the user has difficulty in obtaining full rated voltage with the COARSE and FINE amplitude controls set to maximum.
- Page 5 To the extent that any of its equipment is furnished by a manufacturer other than WPI, the foregoing warranty shall be applicable only to the extent of the warranty furnished by such other manufacturer. This warranty will not apply to appearance terms, such as knobs, handles, dials or the like.
Need help?
Do you have a question about the Omnical 2010 and is the answer not in the manual?
Questions and answers