Advertisement
■I
Facit 4022
Fan-folded tape can be read from cassette
No. 1507 0280-00.
• Insert cassette as shown in Fig. 11 or Fig.
12
.
• Insert the fan-folded tape in the right-hand
cassette compartment as shown in Fig. 9.
See section entitled "Inserting tape and
preparing for reading" for information
about the reference edge of the tape.
• Open the cover and insert the tape in the
reading module in the same way as set forth
in the section entitled "Inserting tape and
preparing for reading".
• Position the tape in the left-hand cassette
compartment so that it will be folded in the
same way as previously. See Fig. 14. Close
the cover by pressing on the white "press-
to-lock" spot.
• Depress the START control.
6
Cleaning
A Light-emitting diode housing
B Light-emitting diode
C Glass window above reading unit
The light-emitting diode, the tape pathway
and the glass window above the reading unit
should be cleaned once a month.
• Clean the tape pathway using a soft hair
brush.
• Carefully wipe the light-emitting diode
glass window above the reading unit using
a soft dry rag.
Splicing tape
1. Cut the ends of the tape pieces between
two feed holes. The cut shall be clean and
absolutely perpendicular to the reference
edge of the tape.
2. Position the two cut ends with their ref¬
erence edges against a straight edge. The
ends shall just contact each other. Allow
no overlap and no gap.
3. Apply a splicing patch as shown in Fig. 16.
If an all-hole patch is used, see to it that the
holes coincide with the holes in the tape. If
an unpunched patch is used, holes cor¬
responding to those in the underlying tape
must be punched out manually. Splicing is
easier if you use a splicer provided with
guide pins and cutter.
Note: The maximum permissible thickness
of the tape including splice is 0.25 mm.
7
Advertisement
