Table of Contents
Advertisement
[4l [REC SELECT] switch settings
The track 4 [REC TRACK] indicator El will flash.
fy| Adjusting the input signal
• Raise the [MASTER] faders to about 7 or 8.
• Press the [REC] button to set track 4 to input monitor.
• While playing each sound source, gradually raise the channel [INPUT] faders until the
level meters are moving at an appropriate level.
[PAN] knob settings
• Turn the channel 1—4 [PAN] knobs far right.
in Equalizer settings
• Use the channel 1—4 shelving equalizers to adjust the tone.
n AUX settings
• Turn the channel 1 and 2 [AUX] send knobs toward "AUX1" and use the [AUX SEND 1]
master knob to adjust the amount of the effect.
• Use the [AUX RTN 1] knob to adjust the amount of the signal sent from the effect unit to
the stereo bus R.
[FB] knob settings
• Gradually rotate the channel 1, 2 and 3 [FB] knobs toward "TRK." You can monitor the
track 1, 2 and 3 playback signal.
Adjusting the monitoring level
• Rotate the [MON] knob gradually to adjust the monitoring level. The track 1, 2. and 3
signals are positioned at center, and the signals of sound sources I, J, K, and L are
positioned on the right in the stereo image.
im Start recording
• Press the [COUNT RESET] button to reset the counter to [000].
• Press the [DOLBY NR] switch to turn Dolby C noise reductioit on.
• After adjusting the input signal, press the [PLAY] button while holding down the [REC]
button to start recording.
• When recording starts, the signal from tracks 1, 2 and 3 will be heard at the level
determined by the [FB] knob setting. Play along with the signal from tracks 1 and 2.
• From time to time, check that the level meter is not going all the way to the top.
• When you finish recording, press the [STOP] button.
5^ Playback
• Press the [0 FTTN] button to rewind the tafie to [OOOJ.
• Change the channel 1 -4 [INPUT SEL] switch settings from "INPUT" to "TAPE."
• Press the [PLAY] button to play back the tape.
• Use the channel 1,2,3, and 4 [INPUT] faders to adjust the level of tracks 1,2,3, and 4.
• Use the channel 1—4 [PAN] kttobs to change the stereo image.
27
Advertisement
Table of Contents
