Craftsman CMXGWASD20735 Operator's Manual page 8

Assembly
Connect Hose and Water Supply to Pump
NOTICE DO NOT run the pump without the water supply
connected and turned on ,
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
I.
Uncoil high pressure hose and attach one end of hose
to base of spray gun, Tighten by hand.
/1:,
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always
be
certain spray gun, nozzles and accessories are
correctly attached.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
~ ~
3. Run water t hrough your garden hose for 30 seconds to
clean out any debris.
NOTICE DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than l OO•F (38°C)).
8
4. Before connecting garden hose to water inlet, inspect
inlet screen (A). Clean screen if it contains debris or
have it replaced if damaged. DO NOT run pressure
washer if inlet screen is damaged.
NOTICE Using a One Way Valve (vacuum breaker or check
valve) at pump inlet could cause pump or Inlet connector
damage.
• There MUST be al least lD II. (3 m) of unrestricted garden
hose between the pressure washer inlet and any device, such
as a vacuum breaker or check valve.
o
Damage to equipment resulting from failure to follow this
mslruclion will void warranty.
5.
Connect the garden hose (not to exceed
50
fl.
(15
m)
In length) to t he water inlet. Tighten by hand.
/1:,
WARNING Risk of eye injury.
A
Spray cou ld splash back or propel objects
~
resulting in serious injury.
o
Always wear indirect vented (chemical splash) safety goggles
marked lo comply with ANSI
Z87 .
I when using or in vicinity
of this equipment.
o
NEVER substitute safety glasses or dry-<:ondition goggles for
indirect vented safety goggles.
6 .
Turn ON the water, press red button
(B)
on the gun
and squeeze the trigger to purge the pump system of
air and impurities.
Checklist Before Starting Engine
Review the unit's assembly to ensure you have performed
all of the following.
1. Be sure to read Operator Safety and Operation before
using pressure washer.
2.
Make sure handle is in place and secure.
3. Check that oil has been added to proper level in the
engine crankcase.
4 . Add proper fuel to fuel tank.
5. Check for properly tightened hose connections.
6.
Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
7. Provide a proper water supply at an adequate flow.
Craftsman.com