Electrical Connections - Zanussi DF67/42FF Instructions For The Use & Care

THE ELECTRICAL CONNECTIONS
WARNING: THIS APPLIANCE MUST
BE EARTHED.
The manufacturer declines any liability should
this safety measure not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off
and the appropriate plug fitted.
The cut off plug should be disposed of to prevent
the hazard of electric shocks in case it should be
plugged into a 13amp socket in another part of
your home.
Important
The wires in this mains lead are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug the colours of the wires
in the mains lead of your appliance may not
correspond with the markings identifying the
terminal in your plug, proceed as follows:
Connect the green and yellow (earth) wire to the
terminal in the plug which is marked with the
letter 'E' or the earth symbol (±) or coloured
green and yellow.
Connect the blue (neutral) wire to the terminal in
the plug which is marked with the letter *N* or
coloured black.
Connect the brown (live) wire to the terminal in
the plug which is marked with the letter 'L' or
coloured red.
The plug moulded onto the cord incorporates a
fuse. For replacement, use a 13amp BS1362 fuse.
Only ASTA approved fuses should be used.
The fuse cover/carrier must be replaced in the
event of changing a fuse. The fuse cover/carrier
colour is the one shown by a coloured insert at
the base of the plug.
6
The plug must not be used if the fuse
cover/carrier is lost. A replacement cover/carrier
can be obtained from your local Zanussi Service
Force Agents whose address is listed on pages
toward the back of this instruction book.
This appliance complies with E.E.C. Directive
no. 82/499 of 7.6.82 relative to radio interference
suppression.