Summary of Contents for Jaybird CoolAireMist COOL-101
- Page 1 Mobile Mist Cooler ► COOL-101 ► COOL-102 OPERATOR’S MANUAL NOTICE Read & Understand Retain for Future Reference...
- Page 2 Purchase Date Model ID Number Vendor Information Notes...
-
Page 3: Table Of Contents
TABLE OF CONTENTS PRODUCT USE Aquafog (CoolAire) mobile PAGE units are intended to General Safety ....condition large volumes of air using water or other Unpacking & Setup ... non-hazardous liquids at Operation &... -
Page 4: General Safety
GENERAL SAFETY The CoolAire Mist uses a high-speed component to atomize water and a water reservoir to hold water supplies. The following safety precautions must be observed at all times: Read operator’s manual carefully and thoroughly. Understand all safety warnings and instructions before attempting operation of the unit. DO NOT OPERATE THE PUMP DRY (WATER SUPPLY IS REQUIRED IN THE SUMP). -
Page 5: Unpacking & Setup
UNPACKING Receiving your CoolAire Unit Locate and remove the screws securing the box to the skid. Lift and save the box incase PICTURE OF A a return is necessary. Remove the strapping BOXED UP COOLAIRE and unpack the unit. Inside the tank locate UNIT ON A SKID the following: WHEN AVAILABLE... -
Page 6: Operation & Maintenance
OPERATION Power Control Switches After filling the tank with at least Flow Control 5 gallons of water, lock the front Valve wheels and connect the power cord. To turn ON, rotate the power Hose switch to ON position. For mist, Connector push on the mist switch. -
Page 7: Troubleshooting
TROUBLESHOOTING WARNING! BEFORE INSPECTION AND/OR SERVICE Issue Tips On What To Check DISCONNECT AND LOCK OUT POWER SOURCE @ INITIAL START-UP 1. Fan Blade Does Not Spin 1. Check power supply. Turn power switch to ON position mode. Check for a damaged/cut power cord. -
Page 8: Service & Repair
SERVICE & REPAIR Fan Motor/Venturi/Blade If you need to replace the fan motor, fan blade or pinned venturi. Use a 5/32” allen wrench to remove the housing. The blade can be removed using a 3/32” allen wrench and the venturi can be removed using a #2 phillips screwdriver. -
Page 9: Electrical Schematic
ELECTRICAL SCHEMATICS... -
Page 10: Replacement Part Id
REPLACEMENT PARTS - IDENTIFICATION Atomizing Fan Head Parts Part No. Atomizing Fan Head Fan Motor 13-500 Venturi Fan Blade Drain Tube Fan Housing (prepped) 502-CP Plumbing Housing Hand-Hold Handle Parts Oscillator Parts Part No. Oscillator Motor (115V) Oscillator Motor (230V) 741-230 Osc. -
Page 11: Warranty
Proof of purchase date and an explanation of the problem or complaint must accompany the returned portion of the machine. Jaybird Manufacturing, Inc. reserves the right to verify the legiti- macy of claimed defects. The provisions of this warranty do not apply to...
Need help?
Do you have a question about the CoolAireMist COOL-101 and is the answer not in the manual?
Questions and answers