Magnavox MBH513 - Bluetooth Stereo Headset Manual

LOCATION OF CONTROLS

1. Power ON/ /OFF Switch h
2. Volume Up Button
3. Volume Down Button
4. Button with Indicators
5. Skip Backward Button
6. Skip Forward Button
7. Play / Pause Button
8. Micro USB B Port (For Charging Only)
9. Earbuds
10. Magnetic Earbuds Holder

POWER SOURCE

The unit has a built‐in Li‐ion rechargeable battery; recharge it before use or when battery is drained as follows:

1. Open the rubber cover on the Micro USB Port.
2. Connect the Micro USB Plug from the supplied connection cable to the Micro USB Port.
3. Connect the full sized USB Plug from the supplied USB Connection Cable to the USB Port on the Computer or USB Charger. (Computer and USB Charger NOT supplied).
4. During charging, the Red Charging Indicator around the Button will illuminate. When finished charging, it will turn off.

Notes:
Your battery will last longer if you're following these simple guidelines for caring and storing.

1. Before first time use, charge it approximately 4 hours until the unit is fully charged.
2. Recharge and store the unit within the temperature range of 5°C~35°C (40°F~95°F).
3. Do not charge longer than 24 hours. Excessive charging or running the Charger and/or Earpieces until battery fully drains will damage battery.
   Battery life will be extended if you keep the battery fully charged.
4. Battery life naturally shortens slowly over time.
5. The rechargeable battery incorporated in this product is not user replaceable.

OPERATION

BT (Bluetooth) Pairing:
The first time you use the unit or pair it to a new Bluetooth Device, pair it as follows:

1. Power on the unit by sliding the Power ON/OFF Switch to ON position. The Blue and Red Indicators around the Button will illuminate and blink. The unit will vibrate briefly.
2. Power on the external BT Device and enter the BT search mode. Start pairing following on the screen instructions from the external BT Device. After pairing:
   • The Blue Indicator will stop blinking.
   • The Red Indicator will not light up.
   • The unit will vibrate briefly.
3. Play the music in the paired BT Device as usual.
4. During playback:
   • Press the or Buttons on the unit to adjust volume level as desire.
   • Press the Button to pause: press again to resume normal playback.
   • Press the or Buttons to skip tracks.
   • Press and holding the or Buttons to fast search.
5. If the unit is paired to a Cell Phone and a call is received while listening to music, press and release the Button to pause the music playback then use the built‐in Microphone to answer the call. When your call is complete, press and releases the Button to resume music playback.
6. When finished listening, slide the Power ON/OFF Switch to OFF position to shut off the unit. Place the Earbuds to the magnetic holder as illustrated below:
   

Notes:

• When the external Bluetooth Device searched the unit, our model number "MBH513" will appear on the display of external Bluetooth Device.
• Pairing code "0000" or "1234" may need to enter.

Normal Operation After Pairing:

• Power on the unit by sliding the Power ON/OFF Switch to ON position. The Blue and Red Indicators around the Button will illuminate and blink. The unit will vibrate briefly.
• Power on the external BT Device and enter to BT mode.
• Wait a few seconds until the unit auto pairs to the external BT Device. Then:
  • The Blue Indicator will stop blinking.
  • The Red Indicator will not light up.
  • The unit will vibrate briefly.
• Play music in the paired BT Device as usual.

TROUBLESHOOTING

Check the following before requesting service:

GENERAL SPECIFICATIONS

Power source:	Built‐in DC 3.7V, 150mAh (0.555WH) rechargeable Li‐ion Battery; Recharge by DC 5V through Micro USB Port
Impedance of the Earbuds:	2 x 20mW; 32 ohm
Audio power:	10mW per channel (Total 20mW, RMS)
BT Version:	4.1
BT Operation Distance:	≧32 Feet in opera area

PACKAGE INCLUDES

1 x Headset
1 x USB Connection Cable (For charging only)
1 x Owner's manual

SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE