Advertisement
Quick Links
A
-I
-O
™
LL
N
NE
PATENT # US 8,448,923
Complete Perimeter Fall Protection System
*WARNING*
Serious injury or death may result if this product is used for purposes other than designed. The manufacturer provides the following instruc-
tions for the use and care of this equipment. It is the responsibility of the purchaser to understand and convey explicit instruction to each user.
The AES Manufacturing/Leading Edge Safety All-In-One™ complies with the requirements of the Federal Occupational Safety and Health
Administration (OSHA) when set up and used according to the manufacturers' instructions.
LIT ID: 406-01
Advertisement
Summary of Contents for Leading Edge ALL-IN-ONE
- Page 1 It is the responsibility of the purchaser to understand and convey explicit instruction to each user. The AES Manufacturing/Leading Edge Safety All-In-One™ complies with the requirements of the Federal Occupational Safety and Health Administration (OSHA) when set up and used according to the manufacturers’...
- Page 2 North Kansas City, MO ALL-IN-ONE COMPLETE FALL PROTECTION SYSTEM is a registered trademark of Leading Edge Safety, LLC 1345 Taney St North Kansas City, MO 64116 www.LeadingEdgeSafety.net Copyright © 2020 by Leading Edge Safety, LLC PRINTED IN THE UNITED STATES OF AMERICA...
- Page 3 ™ I NSTRUCTION ANUAL DIAGRAM OF PARTS The All-In-One™ System is comprised of numerous parts. Below is a diagram of all the parts and names, in a parapet clamp mounting configuration. Top parapet clamp storage opening Bracket adjuster Knob (not shown)
- Page 4 2.0 Flat Edge and Gravel Stop Configuration Wood Applications: Four to six #14 coarse thread wood screws with 1.5" penetration per screw in each All-In-One Base into a solid wood base that is either an integral part of the structure or securely attached to the structure.
- Page 5 ™ I NSTRUCTION ANUAL All testing for the All-In-One was done with the above fastener configurations to meet or exceed the OSHA requirements per 1926.502 for guardrails. All tests were done with fasteners in the All-In-One base roof / floor surface.
- Page 6 10 feet, use the adjustable rails for optimum fit. 7.0 Applications 7.1 The All-In-One is to be used as a railing system for roofs and intermediate level floors. The All-In-One may be used where worker mobility and fall protection are required.
-
Page 7: Inspection Steps
All-In-One system, and the OSHA required ability to withstand a 200 pounds force applied outward or downward anywhere on the All-In-One system. - Page 8 Copyright © 2020 by Leading Edge Safety, LLC 1345 Taney, North Kansas City, MO 64116 www.LeadingEdgeSafety.net PRINTED IN THE UNITED STATES OF AMERICA...
Need help?
Do you have a question about the ALL-IN-ONE and is the answer not in the manual?
Questions and answers