Table of Contents
Advertisement
Quick Links
Water Slide Install Guide
OWNERS MANUAL
Overview
Aquaworx waterslides are manufactured and distributed by Aquaworx
Inc. We are a manufacturer of aquatic waterslides, play features,
filtration, and interactive water playsets. Our plunge waterslides are
designed to be installed in bodies of water with a minimum depth of 4'.
Installation in water depth less than 4' and cause harm or death to the
user. Slides with run out lanes are engineered to ensure proper length
for safe operation.
Building Codes and Standards
The installation of Aquaworx waterslides must follow all local building
codes and standards. Following all local building codes and standards is
the sole responsibility of the contractor.
Installation and Assembly of Slides
Aquaworx manufactures several different types of slides in multiple
configurations. Each slide is engineered per project and will be
assembled accordingly. Specific steps and installation procedures must
be followed to ensure the safety and integrity of the slide. Improper
assembly and installation of Aquaworx slides will void the warranty.
The slide must be installed and tested before any rock work, dirt, or
concrete are installed around the slide. This step is critical to ensure a
safe and problem free install.
Aquaworx Inc 2023
1
Advertisement
Table of Contents
Related Manuals for Playcore AQUA WORX SINGLE 450 OPEN FLUME, 9'4"
Summary of Contents for Playcore AQUA WORX SINGLE 450 OPEN FLUME, 9'4"
- Page 1 Water Slide Install Guide OWNERS MANUAL Overview Aquaworx waterslides are manufactured and distributed by Aquaworx Inc. We are a manufacturer of aquatic waterslides, play features, filtration, and interactive water playsets. Our plunge waterslides are designed to be installed in bodies of water with a minimum depth of 4’. Installation in water depth less than 4’...
- Page 2 Location Instructions Location of the slide is the sole responsibility of the installing contractor. Any placement of the slide must be in accordance with a stamped set of plans from an engineer. This is critical so the slide starts and terminates from the proper points on the plans. Attachment points and footers also require site specific engineering.
- Page 3 Saddle Connection 1. Each saddle must be connected according to engineered specifications 2. Straight parts of the slide must be level on the top from side to side using a 6’ level 3. The saddle must be attached level and below the washers on the bottom of the slide flange using (6) ½”...
- Page 4 WATER SLIDE GEL COAT MAINTENANCE All Aquaworx waterslides are made from gel coat and fiberglass. They must be maintained just like any other fiberglass product. Fiberglass is a common term for fiber-reinforced plastic, or FRP, which is a plastic material strengthened using a fiber cloth. To give the fiberglass a smooth, shiny surface, a material called gelcoat is applied to the outer surface.
- Page 5 Waterslide Safety Plan Hours of Operation: TBD per project or while attendant is present. Attendant/Employee Responsibilities: 1. Start filtration system a minimum of three hours prior to operating the slide 2. Walk slide, steps, landing, flume and platform prior to opening. Ensure slide, steps, landing, flume and platform are clean and safe.
- Page 6 Waterslide Rules Users under 14 years of age must be accompanied by a parent or legal guardian Rides must be a minimum of 42 inches tall Riders must be 300 pounds or less Riders must be in good general health Persons with heart or back conditions shall not ride Pregnant women should not ride Riders must be seated and wait for the attendant approval to...
Need help?
Do you have a question about the AQUA WORX SINGLE 450 OPEN FLUME, 9'4" and is the answer not in the manual?
Questions and answers