universalblue UACC4002-20 Instruction Manual page 7

The procedure for installing the activated carbon filter is as follows.
1. Move away aluminium filters to access to the inside of the
appliance.
2. Inside the appliance you will find a motor. Left and right sides
have an inlet aire.
3. Put the pin of the carbon filter into the rectangular hole of the
fan(as per the arrow A shown below)
4. Push the other side of the carbon filter toward the fan to make it
flat(as per the arrow B shown),and then press filter into fan.
5. If you want to remove the filter, press fastener of filter and
remove it by turning anticlockwise.
6. At the end, place aluminium filters again.
Make sure the filter is tightly closed. Otherwise, it would
loosen and cause danger. When the activated carbon filter is
connected, the suction power will be reduced.
It is compatible
UCTSHAPE60-19 / UCPYRAMID90-19 / UBCA2000-20 /
OHO 6223 M.
with following extractor hoods models:
7