Page 1
The desk panels PULT01 / PULT02 are used for manual control of barriers and / or pedestrian gates, e.g. from a porter's lodge or from a reception. The 1-channel version PULT01 can control only one barrier or one pedestrian gate, with PULT02 two independent barriers or pedestrian gates or also a combination of a barrier and a pedestrian gate can be controlled.
Control and display elements Button S1: Works like a multi-stage switch. By pressing several times, one of two outputs (OUT1/OUT2) is cyclically switched on, then both outputs are switched off. The associated LEDs P1 and P2 indicate the switching status of the two outputs.
Page 3
Functionality with MHTM™ MicroDrive barriers With a desk panel PULT01, one barrier can be operated, with a PULT02, two barriers can be operated via three separate buttons each. For this, the barriers must be set to either operating mode 4 (two-pulse control) or operating mode 2 (deadman).
Page 4
The cables can be extended on site using junction boxes if required. Replacement for previous desk panels PG01 to PG04 A desk panel PULT01 or PULT02 can replace an old desk panel PG01 or PG02. If PG03 or PG04 are to be replaced, two panels must be used.
Page 5
The buttons and the associated LEDs can be assigned individually according to customer requirements. Below you will find a possible example for the use of a desk panel PULT01 / 02 with a mWing. Alternatively, you could also assign the function "Illumination off" or "Inhibit opening" to button S2, for example.