Related Manuals for ProLights GAMMAPIX OUTDOORS GAMMAX48T1X2WF
Summary of Contents for ProLights GAMMAPIX OUTDOORS GAMMAX48T1X2WF
- Page 1 GAMMAPIX OUTDOORS Outdoor LED wall module, SMD1921 WF, p.4,8mm, 3500nit USER MANUAL English version REV.01-07/23...
- Page 2 PROLIGHTS product are trademarks OWNED or licensed by Music & Lights S.r.l., its affiliates, and subsidiaries. PROLIGHTS is a registered trademark by Music & Lights S.r.l. All right reserved. Music & Lights – Via A. Olivetti, snc - 04026 - Minturno (LT) ITALY.
-
Page 3: Table Of Contents
MAINTENANCE AND CLEANING THE PRODUCT............25 MAINTENANCE ON INDOOR PRODUCT ..............25 MAINTENANCE ON OUTDOOR PRODUCT ..............26 CORRECT STARTUP/SHUTDOWN SEQUENCE ............. 26 TRANSPORTATION AND STORAGE ................26 GENERAL INDICATIONS FOR USE ................27 TROUBLESHOOTING ..................... 28 PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 4: Safety Information
• Do not reapply power until repairs have been completed. • Refer any service operation not described in this manual to PROLIGHTS Service team or an authorized PROLIGHTS service center. Installation •... - Page 5 • Warning! Disconnect the fixture from AC mains power and allow to cool for at least 10 minutes before handling. • Only technicians who are authorized by PROLIGHTS or Authorised service partners are permitted to open the fixture. • Users may carry out external cleaning, following the warnings and instructions pro- vided, but any service operation not described in this manual must be referred to a qualified service technician.
-
Page 6: Optional Accessories
• OXACL10 Cavo di alimentazione per led display series L.10 m • SXDCL01 Cavo dati per SIGMAX LED display series assemb. con RJ45, L 140 cm • SXDCL10 Cavo dati per SIGMAX LED display series assemb. con RJ45, L 10 m PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 7: Technical Drawing
2 - TECHNICAL DRAWING GAMMAX48T1X2WF 500 mm 64 mm [19.7 in] [2.5 in] Fig. 01 Weight: 11,4 kg - 25,13 lbs GAMMAX48T1X1WF 500 mm 66 mm [19.7 in] [2.6 in] Fig. 02 Weight: 6,4 kg - 14,11 lbs PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 8: Product Overview
10. LOCKING TAB: to hook cabinet to underside. 11. SIGNAL CONNECTORS: Ethernet connectors for sending and receiving Data Information from the controller. 12. CABLE LOCK: block to secure DATA and Power cables 13. CABINET HANDLE: handy handles for easy assembly. Fig 03 PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 9: Installation
Allign the ground beam GXHGB01 / GXHGB02, then adjust the height of the ground foot to keep the ground beam horizontally. Screw the two down bolts of the DXBS21 to the ground beam GXHGB01 / GXHGB02 throught the back frame DXBSC. Fig 04 PROLIGHTS - GAMMAPIX 29B1X1BF... - Page 10 Install the cabinet. Screw the two top bolts of the DXBS21 to the cabinet. Fig 05 PROLIGHTS - GAMMAPIX 29B1X1BF...
- Page 11 To mount the cabinets horizontally, use the specific side locks by push and turning the locking lever. Complete the line for then assemble the next line. Fig 06 PROLIGHTS - GAMMAPIX 29B1X1BF...
- Page 12 To mount the cabinets vertically, match the pins of the cabinet below with the holes of the cabinet you are mounting. To lock the cabinets vertically, use the upward lock by push and turning the locking lever. Fig 07 PROLIGHTS - GAMMAPIX 29B1X1BF...
- Page 13 Install the DXBSC back plate between cabinets in case of complex installations. Finally, repeat all the previous steps to complete the Video Wall. Fig 08 PROLIGHTS - GAMMAPIX 29B1X1BF...
-
Page 14: Fly Bar Hanging System
FLY BAR HANGING SYSTEM Fasten the fly GXHGB01 / GXHGB02 fly bars at the structure. Install the cabinet on the flybars by matching the pins to the holes in the bars. Fig 09 PROLIGHTS - GAMMAPIX 29B1X1BF... - Page 15 To lock the cabinets vertically, use the upward lock by push and turning the locking lever. Pay attention that the cabinets are well aligned and make sure there are no steps between panels horizontally and on the front of the panels. Fig 10 PROLIGHTS - GAMMAPIX 29B1X1BF...
- Page 16 Use the specific side locks by push and turning the locking lever, to hook the cabinets horizontally Install the DXXJ back plate between cabinets and Flybar. Fig 11 PROLIGHTS - GAMMAPIX 29B1X1BF...
- Page 17 Finally, fasten other cabinets sequentially from top to bottom and from middle to both sides (the number of cabinets in vertical direction shall not be more than 10 cabinets, while i in the horizontal direction is not restricted) Fig 12 PROLIGHTS - GAMMAPIX 29B1X1BF...
-
Page 18: Connection To The Mains Supply
• Connect the power connector into the Mains input socket (100-240 VAC-50/60 Hz). • The product is then ready for its operations and can be controlled through the available input sig- nals on board. • To disconnect power from the product, disconnect the Mains from the socket. PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 19: Data Connection
MAIN AND BACKUP DATA LINE For all Prolights led screen cabinet it’s possible to install a MAIN data line and a BACKUP data line. This allows to see image on led screen in case of MAIN failure. MAIN and BACKUP need to be assigned from the PC software to the outputs of the processor. - Page 20 NOTE: it’s always suggested to use different processor for MAIN line and BACKUP line Last cabinet First cabinet of the chain of the chain DATA MAIN DATA BACKUP Fig. 15 PROLIGHTS - GAMMAPIX 29B1X1BF...
-
Page 21: Led Display Control Setting
• Windows PC • USB cable • Nova LCT software NOTE: PRO user can utilize the software SMARTLCT to configure more complex led screen. It’s pos- sible to see user manual on Novastar web site download page https://www.novastar.tech/downloads/ PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 22: Resolution Management
Led screen resolution 1.843.200 pixels Video Resolution HD 1920x1080 (2.073.600 pixels) Pc output resolution NOTE: HD resolution can be used in this case because is very similar to Sending card resolution the native one Pixel rate 1:1,125 (2.073.600/1.843.200) PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 23: Led Screen Configuration With Novalct
Go in Screen Configuration and Next sword. Go in Screen Connection tab Set the quantity of screen and Configure Set the cabinet resolution and apply to en- Set the number of columns and rows tire row and column Fig. 19 PROLIGHTS - GAMMAPIX 29B1X1BF... - Page 24 Send to HW and Save Set the Backup and press Add Press Send to apply settings and Save # of MAIN PROCESSOR # of BACKUP PROCESSOR # of BACKUP PORT # of MAIN PORT Fig. 20 PROLIGHTS - GAMMAPIX 29B1X1BF...
-
Page 25: Application Example
Power line distribution: 16A LINE 1 16A LINE 2 16A LINE 3 Column 1 Column 4 Column 7 Column 2 Column 5 Column 8 Column 3 Column 6 Column 9 15 cabinets 15 cabinets 15 cabinets PROLIGHTS - GAMMAPIX 29B1X1BF... - Page 26 BACKUP PROCESSOR MAIN PROCESSOR VIDEO SPLITTER VIDEO HDMI OUT HDMI IN HDMI OUT SOURCE Fig. 21 Power line schematics: 16A LINE 1 16A LINE 1 16A LINE 1 Fig. 22 NOTE: screen is seen from behind PROLIGHTS - GAMMAPIX 29B1X1BF...
- Page 27 Configure Data line 1 Configure Data line 2 Configure Data line 3 Backup settings for port 1, 2 and 3 Fig. 23 PROLIGHTS - GAMMAPIX 29B1X1BF...
-
Page 28: Maintenance
• Electrical and functional checks; eventual repairs. WARNING: the use of alcohol or any other detergent or liquid could damage the product. • All other service operations on the product must be carried out by PROLIGHTS, its approved service agents or trained and qualified personnel. -
Page 29: Maintenance On Outdoor Product
LED displays, the ambient temperature and relative humidity for storage shall be ranging from -30°C to +60°C and 10% to 95% RH. Do not store the cabinets in an environment with chemicals that are volatile, corrosive, or flammable. PROLIGHTS - GAMMAPIX 29B1X1BF... -
Page 30: General Indications For Use
• Make sure when assembling the cabinets, to secure the screen and all accessories properly and prevent collapse that may cause damage or danger to people and property, and to use only acces- sories approved by PROLIGHTS. • Switch off the power immediately and contact the professional personnel when the LED display has any abnormal conditions such as peculiar smell, smoke, electric leakage, and abnormal tempera- ture. -
Page 31: Troubleshooting
Check whether the hub card contacts properly with the receiving card • Signal output of the • Check output signals of the receiving card of the previous cabinet previous cabinet, or replace the signal cable faulty PROLIGHTS - GAMMAPIX 29B1X1BF... - Page 32 • Dirty led surface • Clean the fixture regularly. Contact an authorized service center in case of technical problems or not reported in the table can not be resolved by the procedure given in the table. PROLIGHTS - GAMMAPIX 29B1X1BF...
- Page 33 Note...
- Page 34 Note...
- Page 36 PROLIGHTS is a trademark of prolights.it Via A.Olivetti snc MUSIC & LIGHTS S.r.l. support@prolights.it 04026 - Minturno (LT) ITALY musiclights.it Tel: +39 0771 72190...
Need help?
Do you have a question about the GAMMAPIX OUTDOORS GAMMAX48T1X2WF and is the answer not in the manual?
Questions and answers