Chloride 6MIC Series Installation And Operating Instructions

6MIC/2MIC Series
25W-50W Emergency
Luminaire
INSTALLATION AND
OPERATING
INSTRUCTIONS

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety
precautions should always be followed, including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
All servicing should be performed by qualified
personnel only.
Equipment should be mounted in locations and at
heights where it will not be readily subjected to
tampering by unauthorized personnel.
The use of accessory equipment not recommended
by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended use.
Do not use outdoors.
Do not let supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Signify North America Corporation
400 Crossing Blvd, Suite 600
Bridgewater, NJ 08807, USA
Phone: 800-555-0050
www.chloride-lighting.com
CAUTION: Halogen cycle lamp(s) are used in
this equipment. To avoid shattering: Do not
operate lamp in excess of rated voltage, protect
lamp against abrasion and scratches and against
liquids when lamp is operating, dispose of lamp
with care.
Halogen cycle lamps operate at high temperatures.
Do not store or place flammable materials near lamp.
CAUTION: "To avoid electrical overload, total
connected lamp load (factory and field installed)
should not exceed output rating".
SAVE THESE
INSTRUCTIONS
WARNING – Shut off AC power to branch
circuits to which units will be connected. All
wiring should be per N.E.C. Articles 501-4(b) and
local codes.
To maintain warranty, equipment with batteries
must be installed or placed on charge within
prescribed period after shipment.
Signify Canada Ltd
281 Hillmount Road
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
Sept 2022
12NC: 443580520981