1. Set the 2-/4-CHANNEL selector to the "2CH" position.
2. Make connections from the "PRE OUT" terminals of a control
amplifier to the upper pair of "INPUT" terminals of this unit, as
illustrated on the previous page.
3. Then make the connections from this unit to the speaker
systems.
* Be sure all connections are to the correct respective positive
("+") and negative ("—") terminals of the speaker systems.
* Concerning the connections of other components, refer to the
Owner's Manual for each component.
MAC outlet
|
A maximum of 200W can be supplied to another component
connected here. Note that this outlet is "unswitched" (i.e., is not
affected by the POWER
switch of this unit).