Advertisement
4. Remove the chucking pulley.
precision
screwdriver
<-—
magnet
bracket
Om
;
(press pulley)
chucking
pulley
2-3. SERVICE
MODE
1. Operation Check
If the disc table has not been removed
go directly to
step 4, otherwise
begin with step 1.
1.
OnrRon
Remove
the disc and
then
the magnet
from
the
bracket.
Use
the magnet
to fix the disc in position.
Hold the CLOSE
button down.
Connect
test point Tl to ground with a lead wire.
Set the power switch (SW801) to on.
Play should automatically
begin from the fifth track
on
the disc when
in service mode.
[INDICATOR BOARD} — Conductor Side —
CDP- C8ESD/C700/C800
5. When the optical block is down under, move up it by rotating
gear (loading A) in the arrow @) direction with hands.
gear (loading A)
1.
optical pick-up block
2. Display Check
Connect
test point T2 to ground
with a lead wire.
2. Set the power switch (S801) to on.
Press the switches on the panel and check that each
of the corresponding
indicators
lights.
3.
Advertisement
