Table of Contents
Advertisement
2526
Fig. 3
. Stroboscopic Pattern
The stroboscopic
pattern
on the outer
circumference
of the platter is used to check RPM. Adjust RPM with
SPEED ADJUST
knob until the stroboscopic pattern
looks standing still —
the specified power frequencies
and RPM. are shown on the front panel ass'y.
. SIZE SELECT Switch
Setting of this switch is made according to the record
size.
17 cm record: Press this switch in (=).
30cm record: Re-depress this switch out (Mf ).
Note: When it has been already pressed,
press it once again.
. SPEED ADJUST Knob
F<:
Turn this knob in this direction (counterclock-
wise) to increase the platter rotating speed.
S » : Turn this knob in this direction (clockwise) to
decrease the platter rotating speed.
. SPEED Indicators
This indicator indicates RPM 33 or 45. When
RPM
changes,
the
indicator
lamp
lights corresponding
to
that functioning RPM.
. REPEAT Indicator
This indicator
indicates the repeat play of the record.
This indicator lights by pressing the REPEAT
switch
in (m).
. ANTI-SKATING Knob
This knob is used to eliminate the force that pulls the
tonearm
inward
by centripetal
force, and to prevent
the stylus from sliding or applying too much force to
the inner wall of the record groove.
10.
11.
With a conical stylus, set the knob to the scale gradua-
tion marked
with ®@, while using an elliptical stylus or
Shibata
stylus,
set the
knob
to the scale graduation
marked with @@.
. CUEING Lever
To lower the tonearm,
set this lever to "¥ " side,
when lifting it, set this lever to' ¥" side.
. START Switch
To
start
record
play,
press
this switch.
Pressing this
switch causes the tonearm
to automatically detect the
record size and slowly lower at the set position.
. REJECT Switch
To stop record play at halfway, press this switch.
NOTE:Even though REJECT switch is pressed to stop
the
record
halfway,
if the
REPEAT
switch
remains pressed (=), the repeat play function
continues.
When
turning
off
the
power,
re-
depress the REPEAT switch out (M.) and then
press the REJECT switch.
REPEAT Switch
To play a record repeatedly, press this switch in (m=).
NOTE:To
stop repeated
play, re-depress
to set it off
out ( M).
SPEED Switch
Changes
the
turntable
RPM
to correspond
to the
record RPM.
33 1/3 RPM
record:
Re-depress this switch out ( EL ).
Note:When
it has already
been
pressed, press it once again
(Bl).
Advertisement
Table of Contents
