Troubleshooting - Akai AM-M570 Operator's Manual

Troubleshooting
® Amplifier connections are not correct.
Check the amplifier connections.
® Headphones are connected to the PHONES jack.
Disconnect the headphones.
@ VOLUME control is set to o,
Set the VOLUME control to the appropriate position.
@ Input select button is not set to the correct playback
source.
Press the button corresponding to the source you wish to
listen to.
@ The short pins have been removed from the PROCESSOR
IN and OUT jacks.
Replace the short pins.
The VOLUME SCALE indicates a higher volume @ The MUTE button is set to ON.
level than can be heard. Set the button to OFF.
e The protection circuit is engaged,
@ The protection circuit is engaged.
Stop playback as soon as possible, turn off the power, and
then check the speaker cord connections.
Connect a speaker system with an impedance of 8 ohms
or more or turn down the playback volume.
P y- Check the polarity (© and ©) of the connections.
Balance, bass and treble tone controls are not effective.| ° Lape OEE DIRECT button is set to ON.
_@ The tape deck is not properly connected.
Check the connections.
@ The input select button is not set to the source you wish to
record.
Select the source you wish to record.
Connected graphic equalizer or surround processor is | @ The SOURCE DIRECT button is not set to OFF.
not effective. Set the button to OFF.
@ Power is turned off.
Turn the power of all components on.
@ Obstacles placed in front of the remote sensor window of
components.
Remove the obstacles.
@ Batteries are discharged.
Replace them with new ones.
No power.
No sound.
No sound during playback.
Recording cannot be performed.
Remote control operation will not function properly.
numbers and all pertinent data regarding warranty coverage
as well as aclear description of the existing trouble. Then con-
tact your nearest authorized Akai service station.
@ Clean the cabinet with a soft, dry cloth.
@ If the cabinet is very dirty, clean it with a mild detergent.
@ Never use paintthinner, etc. to clean the cabinet as this may
damage the finish.