Hasselblad 500C/M Instruction Manual page 19

Fig. 30. Fold out the roll holder key.
Fig. 31. Turn the key counter-clockwise.
Withdraw the roll holder completely.
Fig. 32. Flip both spool clips. Insert an empty
take-up spool on the take-up side (with the
knob clip) and flip down the clip. Twirl the
spool to ensure that it is correctly seated.
Fig. 33. Insert a roll of film as shown in the il-
lustration and flip down the clip. Make sure
the narrow, glued paper strip securing the pa-
per backing is removed completely.
Fig. 34. Turn the roll holder key on the side
of the magazine c/ockwise so the film clamp
(A, Fig. 35) opens.
Fig. 35. Pull out 3 to 3 1/2 inches of paper
backing from the roll of film and guide it un-
der the film clamp (A).
Fig. 36. Insert the tongue of the paper back-
ing into a slit in the take-up spool.
Fig. 37. Turn the knurled knob clock wise un-
til the arrow on the paper backing is opposite
the delta on the spool clip. Then turn the roll
holder key counter-clockwise.
Fig. 38. Slide the roll holder key into the mag-
azine, jiggling it a little if it does not immedi-
ately click into place, and lock it by turning
the key clockwise.
Fig. 39. Make sure the magazine slide is in-
serted (or that the magazine is attached to the
camera). Fold out the film winding crank (23)
and turn it clockwise until it stops (about 10
turns). Refold the crank. The number '1' will
be displayed in the frame counter (21). The
magazine is now loaded and ready for use.
Fig 39
Note. The magazine can only be removed
from the camera when the magazine slide is
inserted. No exposure can be made when the
magazine slide is inserted with the magazine
on the camera.
17