Table of Contents
Advertisement
REMEMBER - SAFETY FIRST
This Positioner has been designed and built in the UK to provide years of trouble-free
your Positioner safely.
> TO AVOID THE RISK OF A FATAL ELECTRIC SHOCK:
*
DO
NOT
REMOVE
THE
COVER
OF
THE
UNIT
WITHOUT
FIRST
DISCONNECTING THE POSITIONER FROM THE MAINS SUPPLY.
¢
NEVER
ALLOW
ANYONE,
ESPECIALLY
CHILDREN, TO PUSH ANYTHING
INTO HOLES, SLOTS OR ANY OTHER OPENING IN THE CASE.
*
Donotuse or store the Positioner in excessively hot, cold, damp or dusty conditions.
CONNECTION TO THE MAINS SUPPLY
This apparatus operates within the range of 220-240 V AC, 50 Hz mains supplies. DO
NOT CONNECT IT TO DC MAINS. The lead is supplied terminated at one end with a
connector to be inserted into the mains input socket on the rear panel of the apparatus.
DONOT POWER UP THE UNIT UNTIL ALL THE CABLES HAVE BEEN CONNECTED.
Mains Lead Plug Connections (UK and Eire)
The mains lead supplied may or may not have a non-rewireable (moulded) plug. Please
see the section marked with an asterisk (*) if the supplied mains lead does not have a
non-rewireable plug fitted.
Non-Rewireable Plugs
Mains leads fitted with a non-rewireable (moulded) plug incorporate a fuse, the value of
which is indicated on the pin face of the plug. Should the fuse need to be replaced, an
ASTAor BSI approved BS 1362 fuse must be used of the same rating, marked as shown
right.
If the fuse cover is detachable always refit the cover after replacing the fuse. NEVER
use the plug with the fuse cover omitted.
If the fitted plug is not suitable for your socket outlets it should be cut off, after having first
removed the fuse, and an appropriate plug fitted in its place. If this new plug contains
a fuse, its value should be the same as that removed from the non-rewireable plug.
The severed plug must be destroyed immediately to avoid the possible shock hazard
should it be inserted into a 13 A socket elsewhere.
*IF YOU NEED TO FIT A MAINS PLUG THEN FOLLOW THESE INSTRUCTIONS:
Rewireable Plugs
Important: The wires in the mains lead are coloured in accordance with the following
code:
BLUE - Neutral (N)
BROWN - Live (L)
As these colours may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire coloured BLUE must be connected to the terminal marked with the letter N or
coloured BLUE or BLACK.
The wire coloured BROWN must be connected to the terminal marked with the letter L
or coloured BROWN
or RED.
On no account connect either of these wires to the terminal marked E or coloured
GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is clamped over the
sheath of the lead, not simply over the two wires.
A fused plug must be fitted with a 3 A fuse complying with BS 1362. If you are using a
non-fused plug, an external fuse must not exceed 5 A.
Mains Lead Plug Connections (Continental Europe)
The mains lead is supplied already fitted with a 2-pin moulded plug. This mains lead must
not be used in the UK.
b> IF IN DOUBT, CONSULT A COMPETENT ELECTRICIAN
Advertisement
Table of Contents
