Advertisement
Available languages
Available languages
How to mount and connect the TRV/TRU
1.
Rack: hold the transmitter tight to the back side of the control panel's rack on the left, and insert its top side to the designated
elliptic hole, upwards.
2.
Metal case: insert the transmitter into the designated hole in the top side of the control panel's box, from inside out.
3.
Fasten the transmitter using the 4 supplied screws. Make sure the screws are tighten, not to attenuate the radio transmissions.
Rack
4.
Connect the antenna to the transmitter.
5.
Connect the 5-pin Molex cable between the transmitter's "To the System" socket, and the control panel's TRANSMITTER socket.
6.
To use the second frequency, connect the 2-pin Molex connector to the transmitter's "F2" socket; connect its wire to one of the
control panel's outputs- the output should be set to switch to minus when triggered. To permanently broadcast on the second
frequency, connect the wire to a minus terminal.
7.
Test the transmitter.
Antenna length
To calculate the length of the antenna, use the following formula:
��ength ( meters ) =
��requency (MHz)
K: 69.75 for metal antenna; 67.5 for fiberglass antenna
Ordering Information
TRV-100 Low: P/N 8200011
TRV-100 High: P/N 8200010
Metal case
K
TRU-100 Low: P/N 8300005
TRU-100 Medium: P/N 8300009
TRU-100 High: P/N 8300006
-2-
Advertisement
