Zanussi ZR 60/LW Instructions For The Use And Care page 7

c) Slide in the decor panel from the
frameless side, then fasten again the
frame to the door including the previously
removed frame section.
Note
The overall dimensions of the decor panel
should be 1 ± 2 mm smaller than those of
the door, and the thickness should not
exceed 4 mm.
Aligning the worktop with the
kitchen furniture
The appliance is delivered with the
worktop fixed flush with the door.
If a different alignment is required,
proceed as follows (Fig. 2):
Unscrew the screws "A" securing the rear
brackets to the worktop, displace it to
the new location, then secure the screws.