Baumatic BRT200 Instruction Manual page 22

o Remove both of the top hinge screws (1) that hold the top hinge
(2) in place and then remove the top hinge.
o Remove the freezer door by lifting it upwards and away from the
middle hinge pin.
o Place the door on a cushioned surface, so that it does not get
damaged.
o Remove both of the middle hinge screws (3) that hold the
middle hinge (4) in place and then remove the middle hinge.
o Remove the fridge door by lifting it upwards and away from the
lower hinge pin (5).
o Place the door on a cushioned surface, so that it does not get
damaged.
o Remove the lower hinge pin (5) from the right lower hinge
receiver (6) and insert it into the left lower hinge receiver (7).
o Place the fridge door back onto the lower hinge pin (5). It must
remain closed until the door reversal process is completed.
o Turn the middle hinge (4) through 180 degrees from its original
position and then fix it to the left hand side of the cabinet using
the middle hinge screws (3). These screws must be fully
tightened.
o Place the freezer door back onto the middle hinge pin. It must
remain closed until the door reversal process is completed.
o Turn the top hinge (2) through 180 degrees from its original
position. Remove the hinge pin and insert it, so that it is still
facing downwards. Then fix the top hinge to the left hand side of
the cabinet using the top hinge screws (1). These screws must
be fully tightened.
IMPORTANT: Check that both the upper and lower doors open
and shut correctly, without fouling, after you have completed
the door reversal process.
After the door has been reversed, you should check
the door seal of the fridge and freezer door. Neither
seal should be creased or crushed; otherwise there
will be a gap between it and the inside of the door.
22